{"title":"Study of AGC as two area thermal interconnected power system consisting WPG and SPG","authors":"Prasun Sanki, M. Basu, P. Pal","doi":"10.1109/EDCT.2018.8405067","DOIUrl":"https://doi.org/10.1109/EDCT.2018.8405067","url":null,"abstract":"This paper presents automatic generation control (AGC) as a two area thermal interconnected hybrid power generation system where wind power generator (WPG) and solar power generator (SPG) are considered as additional power producers. Both the areas are equipped with thermal generation units with WPG at area 1 and SPG at area 2. Comparison is carried out assuming integral (I), proportional integral (PI) and proportional integral derivative (PID) as a secondary controller for maintaining system frequency. Particle swarm optimization (PSO) is used for optimizing the gain parameters of the controller. System dynamic responses are examined using various loading conditions. Sensitivity analysis are carried out incorporating ±25%, ±50% change in loading conditions and incorporating variation in wind and solar power. All the conditions are suitably presented and the simulation works are performed in MATLAB/Simulink.","PeriodicalId":6507,"journal":{"name":"2018 Emerging Trends in Electronic Devices and Computational Techniques (EDCT)","volume":"52 1","pages":"1-6"},"PeriodicalIF":0.0,"publicationDate":"2018-03-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"82550256","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Analysis of multi-conductor transmission lines (MTL) to find charge distribution and cross-talk","authors":"Avali Ghosh, S. Das, Annapurna Das","doi":"10.1109/EDCT.2018.8405072","DOIUrl":"https://doi.org/10.1109/EDCT.2018.8405072","url":null,"abstract":"In this paper the charge distribution on multi- conductor microstrip lines and the line parameters are calculated by using method of moment technique to find the crosstalk interference in PCB. The results of theoretical analysis are obtained by using MATLAB. Modeling and simulation is done by Ansoft HFSS tool. These results are compared with the experimental results and found in good agreement.","PeriodicalId":6507,"journal":{"name":"2018 Emerging Trends in Electronic Devices and Computational Techniques (EDCT)","volume":"25 1","pages":"1-5"},"PeriodicalIF":0.0,"publicationDate":"2018-03-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"77327167","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Design of a multifrequency slotted circular patch antenna for wireless communication and effect of substrate on the antenna performance","authors":"A. Majumdar, A. Ghosal, Debasish Das","doi":"10.1109/EDCT.2018.8405068","DOIUrl":"https://doi.org/10.1109/EDCT.2018.8405068","url":null,"abstract":"This paper proposes a novel design approach for a dual frequency antenna with dielectric substrate FR4_epoxy. In this paper a comparative analysis is done by using different dielectric substrates and their effect on the antenna performance. It is seen that FR4_epoxy gives the best impedance matching at the design frequency and also produces multi frequency response. The antenna is finally designed using FR4_epoxy as dielectric substrate material and two operating frequency response is achieved at 2 GHz and 2.6 GHz with return loss -21 dB and -23 dB respectively with 5 % and 3.8 % bandwidth each. The antenna is suitable for wireless communication applications.","PeriodicalId":6507,"journal":{"name":"2018 Emerging Trends in Electronic Devices and Computational Techniques (EDCT)","volume":"16 1","pages":"1-3"},"PeriodicalIF":0.0,"publicationDate":"2018-03-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"78989847","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Sky to ground LASER looping for communication server syndrome","authors":"Saranya Bera, R. Chatterjee, K. Pal, R. Dutta","doi":"10.1109/EDCT.2018.8405078","DOIUrl":"https://doi.org/10.1109/EDCT.2018.8405078","url":null,"abstract":"The emergence of communication protocols now lifting with an enormous speed. The optimization and simulation of varied time shared input accessibility through routine paths that goes on with very high sampling rate. Laser is better than RF wave in terms of installation space, cost, speed, and bandwidth. There is no antenna in laser so no antenna drift problem. Our proposed work is aimed to achieve inter-planetary transmission as well as wireless communication within earth. In this paper, we start with a laser modulator which modulates laser to a satellite. This satellite works as a transponder which establishes data transmission to Rover and to base station. The rover is situated in the outer space, the base station is connected to multiple towers on ground from where information is forwarded to service providers by packet switching. The service providers provide audio signals and video signals to users by modulators and demodulators. There is one future prospect of designing a host platform, which will be connected to base station and will provide Ana-Digi signals to different cities for automation purposes.","PeriodicalId":6507,"journal":{"name":"2018 Emerging Trends in Electronic Devices and Computational Techniques (EDCT)","volume":"11 1","pages":"1-5"},"PeriodicalIF":0.0,"publicationDate":"2018-03-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"82395721","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"On the hyperbolic valued measure","authors":"C. Ghosh, S. Biswas","doi":"10.1109/EDCT.2018.8405075","DOIUrl":"https://doi.org/10.1109/EDCT.2018.8405075","url":null,"abstract":"In this article we modified the definition of hyperbolic measure given by R. Kumar and K. Sharma by introducing plus hyperbolic infinity and minus hyperbolic infinity. Also we introduced the concept of hyperbolic valued signed measure and proved some theorems on it. AMS Subject Classification (2010) : 28A12.","PeriodicalId":6507,"journal":{"name":"2018 Emerging Trends in Electronic Devices and Computational Techniques (EDCT)","volume":"15 1","pages":"1-4"},"PeriodicalIF":0.0,"publicationDate":"2018-03-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"90512038","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}