2015 International Conference on Electrical & Electronic Engineering (ICEEE)最新文献_第7页

Extremely low-loss single-mode photonic crystal fiber in the terahertz regime 太赫兹区极低损耗单模光子晶体光纤

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428279

R. Islam, G. Hasanuzzaman, Md Anwar Sadath, S. Rana, Md. Selim Habib

引用次数: 4

Comprehensive modeling and analysis of Variable Speed Wind Turbine using Permanent Magnet Synchronous Generator 永磁同步发电机变速风力发电机组综合建模与分析

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428238

Z. Tasneem, M. Sheikh

引用次数: 1

A complete modeling and analysis of solar system (cell/module/array) based on MATLAB 一个完整的基于MATLAB的太阳能系统(电池/模块/阵列)建模和分析

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428242

A. Ahmed, Khalid Nowaz, Jarin Tasnim, Nashrah Afroze

{"title":"A complete modeling and analysis of solar system (cell/module/array) based on MATLAB","authors":"A. Ahmed, Khalid Nowaz, Jarin Tasnim, Nashrah Afroze","doi":"10.1109/CEEE.2015.7428242","DOIUrl":"https://doi.org/10.1109/CEEE.2015.7428242","url":null,"abstract":"The instalment of photovoltaic power supply to the grid is necessary with a great pace due to scarcity of fossil fuel. The efficiency and cost of the photovoltaic system can be obtained by operating the PV array at the maximum of the PV system. Computer modeling has become important to estimate performance parameters, characteristics and electrical behaviour of a complete PV system (cell, module, array using MATLAB). This work presents computer modeling of a complete PV system. The effects of irradiance, temperature, shading and bypass diode on the output parameter [current, power, maximum power] are considered in this paper. The single diode model with series and parallel resistor is used to model the PV cell. Then the single cell is used to modeling and simulation of PV module and array. A typical 1KW solar panel is used for model evaluation. The developed computer model can be used to predict the behaviour of PV cell, module and array under different environmental and physical parameter. The proposed model can simulate the performance of commercial PV based power system and help to develop control system for driving the load of solar system in maximum power.","PeriodicalId":6490,"journal":{"name":"2015 International Conference on Electrical & Electronic Engineering (ICEEE)","volume":"121 1","pages":"149-152"},"PeriodicalIF":0.0,"publicationDate":"2015-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"75848869","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 7

Computer-aided sleep apnea diagnosis from single-lead electrocardiogram using Dual Tree Complex Wavelet Transform and spectral features 双树复小波变换与频谱特征对单导联心电图睡眠呼吸暂停的计算机辅助诊断

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428289

A. Hassan, M. A. Haque

引用次数: 37

An advanced controller to improve the power quality of microgrid connected converter 一种改善微电网并网变流器电能质量的先进控制器

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428251

Omar Farrok, Md. Rafiqul Islam Sheikh, Md. Rabiul Islam

{"title":"An advanced controller to improve the power quality of microgrid connected converter","authors":"Omar Farrok, Md. Rafiqul Islam Sheikh, Md. Rabiul Islam","doi":"10.1109/CEEE.2015.7428251","DOIUrl":"https://doi.org/10.1109/CEEE.2015.7428251","url":null,"abstract":"This paper presents a new controller of a microgrid connected converter to reduce harmonic components to ensure high quality of electrical power, although the microgrid connected inverter with an LCL filter has the ability of attenuating the higher order harmonics. The major advantage of the proposed controller is that it can attenuate both the higher and lower order harmonics with a small size line filter which minimize both the physical size and cost of the system. Fast Fourier transform (FFT) and total harmonic distortion (THD) of the output voltage waveform is measured and compared to the preset tolerance level. The controller uses new type of modulation by using feed-forward control instead of feedback control to obtain quick response. Comparison of different output waveforms of converter using different modulation like space vector modulation (SVM), advanced pulse width modulation (PWM) and the proposed modulation are presented. The proposed controller using feed-forward scheme can effectively suppress the distortion arises from the grid voltage harmonics as well as regulate for different load conditions and power generation. MATLAB/Simulink is used for simulation of the entire system.","PeriodicalId":6490,"journal":{"name":"2015 International Conference on Electrical & Electronic Engineering (ICEEE)","volume":"19 1","pages":"185-188"},"PeriodicalIF":0.0,"publicationDate":"2015-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"74133090","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 6

Fabrication, microstructural characterization and wear characteristics of A380 alloy-alumina composites A380合金-氧化铝复合材料的制备、显微组织表征及磨损特性

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428274

Sheikh Jaber Nurani, C. Saha, M. Karim, Md. Nasrul Haque, Md Abdul Halim

{"title":"Fabrication, microstructural characterization and wear characteristics of A380 alloy-alumina composites","authors":"Sheikh Jaber Nurani, C. Saha, M. Karim, Md. Nasrul Haque, Md Abdul Halim","doi":"10.1109/CEEE.2015.7428274","DOIUrl":"https://doi.org/10.1109/CEEE.2015.7428274","url":null,"abstract":"To obtain better mechanical and tribological properties than aluminium alloys aluminium is reinforced with alumina particles making aluminium metal matrix composites. In this work scrap piston A380 alloy was used as the matrix alloy. Alumina particles were added by 5%, 10% and 15% into matrix alloy respectively to form desired composites by stir casting technique. Pin on disc wear testing machine with counter surface as steel disc of hardness HRC 32 and surface roughness of 0.62 μm was used to conduct the wear test. In result composites showed superior wear resistance property over A380 alloy. The effect of load, sliding speed and sliding distance on wear behaviour were also examined in this study. Wear mechanism was identified from the worn surface. Both optical and scanning electron microscope (SEM) of the composites was performed to determine the microstructures. Optical micrograph shows grain size decreases with addition of alumina particles. EDS analysis was performed to confirm the presence of α-Al matrix, primary Si particles and intermetallic. As a general method, phase compositions were analyzed by using a scanning electron microscope (SEM) equipped with an energy dispersive spectroscopy (EDS). Optical microstructures were consistent with the SEM micrographs.","PeriodicalId":6490,"journal":{"name":"2015 International Conference on Electrical & Electronic Engineering (ICEEE)","volume":"4 1","pages":"269-272"},"PeriodicalIF":0.0,"publicationDate":"2015-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"85291419","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 0

Biometric smart attendance kit with fingerprint scanner by using microcontroller 采用单片机的指纹识别智能考勤套件

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428261

Fahad Bin-Mazhar, Oli Ahamed, Md Rasedujjaman

引用次数: 10

Experimental investigation and analysis of clock model and sensor networks agents time synchronization 时钟模型与传感器网络代理时间同步的实验研究与分析

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428241

Md Asgar Hossain, M. Mukit

引用次数: 0

An approach for letter recognition system modeling based on prominent features of EEG 基于脑电图显著特征的字母识别系统建模方法

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428293

Shabnam Wahed, Monira Islam, Protik Chandra Biswas, Muhammad Masud Rana, Debarati Nath, Mohiudding Ahmad

引用次数: 1

Photovoltaic characteristics of single wall carbon nanotube (CNT): PCBM organic solar cell-effect of CNT chirality variation 单壁碳纳米管(CNT)的光伏特性:碳纳米管手性变化对有机太阳能电池的影响

2015 International Conference on Electrical & Electronic Engineering (ICEEE) Pub Date : 2015-11-01 DOI: 10.1109/CEEE.2015.7428247

A. H. Chowdhury, S. M. Mominuzzaman

{"title":"Photovoltaic characteristics of single wall carbon nanotube (CNT): PCBM organic solar cell-effect of CNT chirality variation","authors":"A. H. Chowdhury, S. M. Mominuzzaman","doi":"10.1109/CEEE.2015.7428247","DOIUrl":"https://doi.org/10.1109/CEEE.2015.7428247","url":null,"abstract":"This paper advances the field of single wall carbon nanotube (SWCNT) organic solar cells by studying the photovoltaic characteristics to understand the optimization process for obtaining better power conversion efficiency (PCE). Open circuit voltage (Voc) is interpreted with the energy offset between donor and acceptor level. Quantum efficiency (QE) has been simulated considering absorption, exciton dissociation and charge collection efficiency for OPV materials. The simulated QE summed over the solar spectrum to find the short circuit current density (Jsc). Single chiral semiconducting single wall carbon nanotube (s-SWCNTs) are used as the donor with (6,6)-phenyl-C61- butyric acid methyl ester (PCBM). By changing the chirality of SWCNTs, the photovoltaic parameters are optimized. Highest Voc of 0.7849V has been achieved for (8,1) chiral CNT. Jsc can be maximized up to 3.65mA/cm2 and fill factor to 0.466 for (10,3) CNT. Finally PCE of around 1% has been found for chirality (10,3) and (11,1). In this work PCE has been increased through a range of about 14.75% by changing the chirality of CNTs.","PeriodicalId":6490,"journal":{"name":"2015 International Conference on Electrical & Electronic Engineering (ICEEE)","volume":"17 1","pages":"169-172"},"PeriodicalIF":0.0,"publicationDate":"2015-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"88598860","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 1