{"title":"Abstracts of papers presented at the ISLAR (International Symposium on Laboratory Automation and Robotics) 1996.","authors":"","doi":"10.1155/S1463924697000102","DOIUrl":"https://doi.org/10.1155/S1463924697000102","url":null,"abstract":"","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 3","pages":"61-89"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000102","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27795085","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Single standard calibration and data processing in flow injection titration based on concentration gradients.","authors":"M C Araújo, A V Santos, R S Honorato, C Pasquini","doi":"10.1155/S1463924697000163","DOIUrl":"https://doi.org/10.1155/S1463924697000163","url":null,"abstract":"<p><p>This paper describes use of gradients of concentration generated in flow injection (FI) systems to perform determinations based on points where the concentration of titrant and analyte are at stoichiometric ratio. Two procedures were developed. In one procedure the titrant is injected in a FI manifold and merges with the sample which is continuously pumped towards the detector. In the other procedure the sample is injected and merged with the titrant which is continuously pumped. Both techniques make use of concentration gradients of the sample or titrant generated in FI manifolds that contain a mixing chamber. This gradient is calibrated employing only one standard solution (usually the titrant) in order to convert any detector signal, obtained in the elapsed time after injection, to instantaneous concentration values. The flow system is microcomputer controlled and data are treated to locate points where the concentration of titrant and analyte are at the stoichiometric ratio. These points are found in abrupt changes of the signal x concentration curves obtained in the presence of the reaction. The method has been evaluated for determination of Fe(II) and acetic acid by spectrophotometric and conductimetric detection, respectively. Results show a mean relative standard deviation lower than 1%, an average accuracy of 1% and a high sampling processing capability (40 to 60 samples per hour).</p>","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 5","pages":"157-64"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000163","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27795090","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
D M Obzansky, E G Gorman, S P Kramer, I S Masulli, E A Nuzzaci, W F Skogen
{"title":"Development and analytical performance of an automated screening method for cannabinoids on the Dimension clinical chemistry system.","authors":"D M Obzansky, E G Gorman, S P Kramer, I S Masulli, E A Nuzzaci, W F Skogen","doi":"10.1155/S1463924697000187","DOIUrl":"https://doi.org/10.1155/S1463924697000187","url":null,"abstract":"<p><p>A fully automated, random access method for the determination of cannabinoids (UTHC) was developed for the Dimension AR and XL clinical chemistry systems. The method utilizes Abuscreen ONLINE reagents and a multianalyte liquid calibrator containing 11-nor-Delta(9)-THC-9-carboxylic acid. Within-run and total reproducibility, determined using NCCLS protocol EP5- T2, was less than 0.6% and 1.6% CV, respectively, at all concentrations. Calibration stability was retained for at least 30 days. An extensive evaluation of non-structurally related drugs and various physiological substances indicated lack of interference in the method. No sample carry-over was observed following a specimen containing 1886 ng/ml 11-nor-Delta(9)-THC-9-carboxylic acid. A 99.1% agreement (N = 445 samples) was found between an EMIT based method on the aca discrete clinical analyser and the Dimension UTHC method.Dimension clinical chemistry system and aca discrete clinical analyser are registered trademarks of Dade International.</p>","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 5","pages":"169-73"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000187","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27795092","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"1. The Data Librarian: laboratories today-the need for the Librarian.","authors":"J Liscouski","doi":"10.1155/S1463924697000230","DOIUrl":"https://doi.org/10.1155/S1463924697000230","url":null,"abstract":"<p><p>This first part of 'The Data Librarian' describes the current situation in analytical laboratories and the need for the Data Librarian. The second part of the paper (Liscouski, J., 1997, Journal of Automatic Chemistry, 19, 199-204) will examine the features of the Data Librarian.</p>","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 6","pages":"193-7"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000230","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27794994","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Flow injection analysis of iron in rain water with thiocyanate and surfactant.","authors":"A N Tripathi, S Ehikhalikar, K S Patel","doi":"10.1155/S1463924697000072","DOIUrl":"https://doi.org/10.1155/S1463924697000072","url":null,"abstract":"<p><p>This paper explains a new procedure for flow injection analysis (FIA) determination of iron in rain water based on the colour reaction of Fe(3+) with thiocyanate ions in the presence of the cationic surfactant cetylpyridinium chloride (CPC). The value of apparent molar absorptivity of the complex in terms of iron is (2.00) x 10(4) l mole(-1) cm(-1) at an absorption maximum of 490 nm. The detection limit of the method is 8 ppb Fe. The sample throughput is 90 samples/h at a flow rate of 4.0 ml/min. The reaction mechanism, optimization of FIA variables, and effect of various types of surfactant are described. None of the tested anions and cations interfered with the determination of iron. The method was used for the quantification and flux determination of iron in rain water.</p>","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 2","pages":"45-50"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000072","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27795082","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Abstracts of papers presented at the 1997 Pittsburgh Conference.","authors":"","doi":"10.1155/S1463924697000114","DOIUrl":"https://doi.org/10.1155/S1463924697000114","url":null,"abstract":"","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 4","pages":"91-131"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000114","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27795086","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
C Porte, M Caron-Poussin, S Carot, C Couriol, M M Moreno, A Delacroix
{"title":"Optimization of control parameters of a hot cold controller by means of Simplex type methods.","authors":"C Porte, M Caron-Poussin, S Carot, C Couriol, M M Moreno, A Delacroix","doi":"10.1155/S1463924697000035","DOIUrl":"https://doi.org/10.1155/S1463924697000035","url":null,"abstract":"<p><p>This paper describes a hot/cold controller for regulating crystallization operations. The system was identified with a common method (the Broida method) and the parameters were obtained by the Ziegler-Nichols method. The paper shows that this empirical method will only allow a qualitative approach to regulation and that, in some instances, the parameters obtained are unreliable and therefore cannot be used to cancel variations between the set point and the actual values. Optimization methods were used to determine the regulation parameters and solve this identcation problem. It was found that the weighted centroid method was the best one.</p>","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 1","pages":"15-26"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000035","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27795079","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Stabilized filter-supported bilayer lipid membranes (BLMs) for automated flow monitoring of compounds of clinical, pharmaceutical, environmental and industrial interest.","authors":"D P Nikolelis, C G Siontorou","doi":"10.1155/S1463924697000011","DOIUrl":"https://doi.org/10.1155/S1463924697000011","url":null,"abstract":"<p><p>This paper describes the results of analytical applications of electrochemical biosensors based on bilayer lipid membranes (BLMs) for the automated rapid and sensitive flow monitoring of substrates of hydrolytic enzymes, antigens and triazine herbicides. BLMs, composed of mixtures of egg phosphatidylcholine (egg PC) and dipalmitoylphosphatidic acid (DPPA), were supported on ultrafiltration membranes (glass microfibre or polycarbonate filters) which were found to enhance their stability for flow experiments. The proteins (enzymes, antibodies) were incorporated into a floating lipid matrix at an air-electrolyte interface, and then a casting procedure was used to deliver the lipid onto the filter supports for BLM formation. Injections of the analyte were made into flowing streams of the carrier electrolyte solution and a current transient signal was obtained with a magnitude related to the analyte concentration. Substrates of hydrolytic enzyme reactions (acetylcholine, urea and penicillin) could be determined at the micromolar level with a maximum rate of 220 samples/h, whereas antigens (thyroxin) and triazine herbicides (simazine, atrazine and propazine) could be monitored at the nanomolar level in less than 2 min. The time of appearance of the transient response obtained for herbicides was increased to the order of simazine, atrazine and propazine which has permitted analysis of these triazines in mixtures.</p>","PeriodicalId":22600,"journal":{"name":"The Journal of Automatic Chemistry","volume":"19 1","pages":"1-8"},"PeriodicalIF":0.0,"publicationDate":"1997-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://sci-hub-pdf.com/10.1155/S1463924697000011","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"27794493","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"OA","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}