2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC)最新文献_第2页

An innovative exciting coil design for magneto-optic imaging in nondestructive evaluation 一种用于无损评价磁光成像的创新激励线圈设计

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555724

Yuhua Cheng, Xingmake Liu, Yiming Deng

引用次数: 2

Analysis of spectral signatures of stator currents on a three-phase induction motor operating in non stationary mode for rotational speed and slip detection using rotor slot harmonics 基于转子槽谐波的三相异步电动机转速和转差检测定子电流频谱特征分析

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555542

Wilton Lacerda Silva, Amauri Oliveira

引用次数: 4

A new inductive proximity sensor as a guiding tool for removing metal shrapnel during surgery 一种新型感应式接近传感器在手术中用于金属弹片清除的引导工具

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555380

M. Sakthivel, B. George, J. Venkatraman, M. Sivaprakasam

{"title":"A new inductive proximity sensor as a guiding tool for removing metal shrapnel during surgery","authors":"M. Sakthivel, B. George, J. Venkatraman, M. Sivaprakasam","doi":"10.1109/I2MTC.2013.6555380","DOIUrl":"https://doi.org/10.1109/I2MTC.2013.6555380","url":null,"abstract":"In this paper, an inductive proximity sensor with a longer range when compared to its diameter is presented. This sensor is intended to guide doctors, while performing surgery to remove metal shrapnel from victims of bomb blasts, gun fire, land mines etc. Presently doctors rely on imaging systems to locate shrapnel in the victim's body before surgery. Effectiveness of surgery and recovery solely depends on the doctors' skill to trace the shrapnel. In some cases the shrapnel may be visible in the images, but it may be untraceable during surgery. So in such cases, an inductive proximity sensor which is small enough to be introduced into the victim's body and can direct the recovery tool effectively to the exact location of the shrapnel, during the surgery, will be very useful to the doctor. Such a sensor, along with its details and experimental results are presented in this paper. This sensor works on a new comparison based method to detect tiny targets, as the detector size is a constraint here. The sensor can detect shrapnel materials such as steel, brass and Aluminium. A smaller, modified version of this sensor is also presented in the paper, along with a study of the effect of body tissues on sensor performance.","PeriodicalId":432388,"journal":{"name":"2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC)","volume":"128 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2013-05-06","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"122501845","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 9

Use of an inductive divider for AC voltage ratio calibration 使用电感分压器进行交流电压比校准

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555398

K. Draxler, R. Styblíková

引用次数: 1

Identification of nonlinear LFR systems with two nonlinearities 具有两个非线性的非线性LFR系统辨识

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555441

A. V. Mulders, L. Vanbeylen

引用次数: 5

Non-contact EM measurement of the properties of power station steels taken from service 电站用钢性能的非接触式电磁测量

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555679

N. Karimian, W. Yin, J. Liu, X. Hao, M. Strangwood, C. Davis, A. Peyton

引用次数: 5

Design and characterization of curvature sensors based on plastic optical fibers for structural monitoring 结构监测用塑料光纤曲率传感器的设计与表征

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555565

A. Vallan, A. Carullo, M. L. Casalicchio, G. Perrone

引用次数: 8

Precise 10 and 20 kV DC/AC resistive divider 精确的10和20kv直流/交流电阻分压器

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555520

R. Procházka, K. Draxler, J. Hlavacek, R. Styblíková

{"title":"Precise 10 and 20 kV DC/AC resistive divider","authors":"R. Procházka, K. Draxler, J. Hlavacek, R. Styblíková","doi":"10.1109/I2MTC.2013.6555520","DOIUrl":"https://doi.org/10.1109/I2MTC.2013.6555520","url":null,"abstract":"This paper describes the structure and calibration of a resistive divider for DC voltage measurement in the range up to 10 kV or 20 kV. The divider consists of twenty 9.99 MΩ high-voltage resistors and one 100 kΩ output resistor. Circular electrodes create parallel capacitor to appropriate resistors. These thin-film resistors have a tolerance of resistance 0.1 %. The structure is designed to minimize the influence of corona currents and leakage resistance between resistors. This paper describes resistor calibration process of, including verification of their voltage dependence. The divider ratio constant and its uncertainty are calculated on the basis of this calibration. The advantage of the proposed procedure is in easy divider recalibration process. A simple recalibration process is necessary due to the long term usage. The proposed DC voltage divider can be used to measure AC respective impulse voltages as well. The frequency independency in given frequency range is then required. The application of compensatory capacity and automatic correction method ensure the correct compensation of voltage divider.","PeriodicalId":432388,"journal":{"name":"2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC)","volume":"36 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2013-05-06","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"122113227","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 1

Full four capacitor circuit compensation for inductive power transfer 全四电容电路补偿感应功率传输

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555406

R. Azambuja, V. Brusamarello, S. Haffner, R. W. Porto

引用次数: 12

Instrumentation for safe vehicular flow in intelligent traffic control systems using wireless networks 使用无线网络的智能交通控制系统中安全车辆流量的仪表

2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Pub Date : 2013-05-06 DOI: 10.1109/I2MTC.2013.6555623

H. Eren, H. M. Pakka, A. Alghamdi, Yizuo Yue

{"title":"Instrumentation for safe vehicular flow in intelligent traffic control systems using wireless networks","authors":"H. Eren, H. M. Pakka, A. Alghamdi, Yizuo Yue","doi":"10.1109/I2MTC.2013.6555623","DOIUrl":"https://doi.org/10.1109/I2MTC.2013.6555623","url":null,"abstract":"This paper describes a ZigBee based wireless system to assists traffic flow on arterial urban roads. Real-time simulation in laboratory environment is conducted to determine the traffic throughput to avoid possible congestions or ease existing congestions. Random numbers are generated to mimic approaching traffic, and this information is shared by a ZigBeebased real-time wirelessly network. Wireless nodes are connected to different PLCs representing different traffic lights in a cluster. Once the information is shared the timing and sequencing decisions are taken collectively in a synchronized manner. In this paper, the information is displayed on SCADA connected to each PLC for viewing the characteristics of continuous vehicular flow. It is found that the topology of the network can play an important role in the throughput of data, which may be critical in safety critical operations such as the control of traffic lights. This paper aims to highlight some of the possible effects of dataflow flow and time-delays faced by modern intelligent control of traffic lights.","PeriodicalId":432388,"journal":{"name":"2013 IEEE International Instrumentation and Measurement Technology Conference (I2MTC)","volume":"27 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2013-05-06","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"129813907","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 12