2016 International Conference on System Reliability and Science (ICSRS)最新文献_第2页

Comparative study of data warehouses modeling approaches: Inmon, Kimball and Data Vault 数据仓库建模方法的比较研究:Inmon, Kimball和data Vault

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815845

L. Yessad, Aissa Labiod

引用次数: 20

Selection of suitable ANN structure for fault classification in STATCOM connected transmission line STATCOM连接传输线故障分类中ANN结构的选择

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815831

R. Hasabe, A. Vaidya

引用次数: 0

Analysis on design points of large synchronous condenser for UHVDC project 特高压直流工程大型同步冷凝器设计要点分析

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815830

Cui Yibo, Tao Qian, Ling Zaixun, Cai Wanli, Ruan Ling, Yang Pengcheng

{"title":"Analysis on design points of large synchronous condenser for UHVDC project","authors":"Cui Yibo, Tao Qian, Ling Zaixun, Cai Wanli, Ruan Ling, Yang Pengcheng","doi":"10.1109/ICSRS.2016.7815830","DOIUrl":"https://doi.org/10.1109/ICSRS.2016.7815830","url":null,"abstract":"To improve the ability of reactive power support at Ultra High Voltage Direct Current (UHVDC) project sending and receiving terminals, State Grid Corporation will install large synchronous condensers which gives high requirements in transient and dynamic characteristics. Some performance indexes of large synchronous condenser are very different from traditional turbo-generator. The change of performance index will have great influence on equipment design, production, operation and manufacture. And there is contradiction between the higher transient, dynamic characteristics and equipment safety. The paper analysised the performance index, technical requirements, equipment characteristics of large synchronous condenser for UHVDC project. Compared with the 412MVA synchronous turbo-generator. Mainly analyzed the differences and influences of leading phase operation capability, short-circuit-ratio, direct-axis transient time constant, direct-axis subtransient reactance and forced excitation ability. Finally the paper gives some advices on improving the design of large synchronous condenser for UHVDC project to ensure the quality of performance index and the safety of equipment.","PeriodicalId":164248,"journal":{"name":"2016 International Conference on System Reliability and Science (ICSRS)","volume":"30 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2016-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"129855879","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 10

Integrated circuit fault prognostics based on the delay characteristics of the clock network 基于时钟网络时延特性的集成电路故障预测

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815832

Lin Ye, Yu-dong Lu, Xin Wang, Yun Huang, Chunhua He, B. Hou

引用次数: 1

Influence investigation from the forced draught fan mode on the characteristics of an air-cooled power plant 强制风机模式对风冷电厂特性的影响研究

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815833

Weifeng He

引用次数: 1

Class coverage GUI testing for Android applications 类覆盖GUI测试Android应用程序

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815843

Sathyanarayanan Subramanian, Thomas Singleton, O. Ariss

{"title":"Class coverage GUI testing for Android applications","authors":"Sathyanarayanan Subramanian, Thomas Singleton, O. Ariss","doi":"10.1109/ICSRS.2016.7815843","DOIUrl":"https://doi.org/10.1109/ICSRS.2016.7815843","url":null,"abstract":"Mobile devices such as smartphones and tablets have become an integral part of a person's life. These portable devices opened up a new software market for mobile application development resulting in various applications from healthcare, banking till entertainment. Therefore, there is a need for mobile applications to be reliable and maintainable. In this paper we introduce an equivalent class based technique for testing the graphical user interface of Android applications. This technique is a specification based approach, in which test cases are generated based on the functionalities and the graphical user interface specification. For each possible user interface event a set of test cases are generated using equivalence class partitioning approach. Once the test cases are generated for the given application, the app is executed based on the generated test cases and results are compared with the other testing techniques. From the obtained results we can infer that our approach detects more bugs than other previous work. In addition, this approach helps in the generation of test cases at an early in the app development life cycle.","PeriodicalId":164248,"journal":{"name":"2016 International Conference on System Reliability and Science (ICSRS)","volume":"3 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2016-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"121307217","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 2

Oil spill risk analysis of tanker berthing and handling operation based on fuzzy bow-tie model 基于模糊领结模型的油轮靠泊装卸作业溢油风险分析

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815841

Cui Wengang, Fan Houming, Yao Xi, Yang Yu, Ma Mengzhi

引用次数: 0

A multilevel compensator with reduced number of switches used as auto-rectifies active filter for harmonics elimination 具有减少开关数量的多电平补偿器，用作消除谐波的自整流有源滤波器

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815828

Zahzouh Zoubir, Bouzaouit Azzedine, Gahgah Mounir, Rahai Lias

{"title":"A multilevel compensator with reduced number of switches used as auto-rectifies active filter for harmonics elimination","authors":"Zahzouh Zoubir, Bouzaouit Azzedine, Gahgah Mounir, Rahai Lias","doi":"10.1109/ICSRS.2016.7815828","DOIUrl":"https://doi.org/10.1109/ICSRS.2016.7815828","url":null,"abstract":"Active power filters are used to improve the energy quality of the electrical distribution networks by the harmonic elimination and correcting of the power factor. However, many conventional configurations of active filters are constituted by a significant number of semiconductors that generate a crowded installation with a complicated control, high cost price of his designs and power losses due to switching of semiconductors. For these reasons, the innovation of these configurations is required. This article, presents a proposed structure of multilevel active power filter auto-rectifies with a reduced number of switches. It is controlled by an easy flowchart permitting a functioning fast and efficient to eliminate the named problems of traditional structures. The use of this structure also reduces to half the number of DC bus capacities of its supply. Conventional systems such as seven levels inverter NPC-type require twelve power switches, six capacities of DC bus and diodes of neutral point clamped. The proposed model retained its ability to produce the same seven levels of voltage with only a small number of eight bipolar switches, three capacities of DC bus and none diode used for the neutral point clamped. The simulation results illustrate an important reduction in THD of current supply from 25.35% to 1.82%, that's less significant than the value conform to IEEE standards of 5% with a good compensation of reactive power.","PeriodicalId":164248,"journal":{"name":"2016 International Conference on System Reliability and Science (ICSRS)","volume":"8 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2016-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"115426314","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 0

Design of an automated vibration monitoring system for condition based maintenance of a lathe machine (Case study) 车床状态维修振动自动监测系统设计(案例分析)

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815838

M. N. Chikuruwo, Laurence Maregedze, T. Garikayi

{"title":"Design of an automated vibration monitoring system for condition based maintenance of a lathe machine (Case study)","authors":"M. N. Chikuruwo, Laurence Maregedze, T. Garikayi","doi":"10.1109/ICSRS.2016.7815838","DOIUrl":"https://doi.org/10.1109/ICSRS.2016.7815838","url":null,"abstract":"This article presents an automated vibration monitoring system for a lathe machine. This study was motivated by the fact that machine production time was wasted during planned maintenance when, most times, the machines did not require any maintenance at all. Also, the periodic intervals used did not depict the correct ageing of the machine components which resulted in unexpected failure of the machine. Planned maintenance schedules are done with the assumption that the machine is going to breakdown after a certain period of time. The aim of this research was to come up with a vibration monitoring system for a lathe machine, which included incorporating an electronic circuit in the system, use of liquid crystal display for improved user interface and use of vibration sensors to determine the vibration level of the machine. Experimental research design was used to determine the acceptable ranges of vibration amplitudes in order to classify the amplitude into 4 groups namely: extremely rough, rough, acceptable and smooth. The designed system produced consistent vibration amplitudes for both machining and nonmachining operation. The system used different indicators linked to the main processor of the circuit which monitors the machine real-time performance. It was capable of alerting the user when the vibration amplitude was out of range and also to switch off the machine when the vibration threshold was exceeded. The vibration monitoring system helps in damage control and enables preventive measures to be taken before damage occurs.","PeriodicalId":164248,"journal":{"name":"2016 International Conference on System Reliability and Science (ICSRS)","volume":"122 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2016-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"114879139","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}

引用次数: 6

A modeling method for monitoring tool wear condition based on adaptive dynamic non-bias least square support vector machine 基于自适应动态无偏差最小二乘支持向量机的刀具磨损状态监测建模方法

2016 International Conference on System Reliability and Science (ICSRS) Pub Date : 2016-11-01 DOI: 10.1109/ICSRS.2016.7815837

Zhu Mengzhou, Xiao Pengfei, Z. Chaoyong

引用次数: 3