{"title":"Statement of Peer Review","authors":"M. Kopec","doi":"10.3390/psf2022004034","DOIUrl":"https://doi.org/10.3390/psf2022004034","url":null,"abstract":"","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"14 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-09-15","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"126849251","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
P. Cerasi, M. Duda, L. Edvardsen, N. Agofack, M. Bhuiyan
{"title":"Effect of Field Caprock Shale Exposure to CO2 on Its Mechanical Properties—A Comparison of Experimental Techniques","authors":"P. Cerasi, M. Duda, L. Edvardsen, N. Agofack, M. Bhuiyan","doi":"10.3390/psf2022004033","DOIUrl":"https://doi.org/10.3390/psf2022004033","url":null,"abstract":": Laboratory tests were performed on the Draupne shale formation, which may serve as a seal over CO 2 storage sites. Different techniques were used to assess the integrity and mechanical properties of the shale, with the main objective of investigating whether exposure to CO 2 would in any manner alter these properties. The laboratory methods used encompass traditional triaxial tests; however, with fluid substitution prior to increasing axial stress to failure. These tests were conducted on smaller cylindrical plugs than standard, taking advantage of the finer grained nature of the shale. Another set of experiments used the low-frequency technique, whereby small amplitude, cyclic axial strains are applied on the specimen, allowing a direct measurement of stiffness. Long exposure, with change of fluid from brine to CO 2 , allowed for quantifying small changes in stiffness, thanks to the many repeated cycles of non-destructive testing. In a final experimental technique, the punch test, shear strength of the same material was obtained by cutting a central disk from a larger intact shale disk, while measuring the shear force needed to perform the cut.","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"100 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-09-13","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"122417522","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"On the Modeling of Isolation and Vibration Control Using Laminated Composite Materials","authors":"S. Ghoneam, Ahmed Hamada, A. Elkholy","doi":"10.3390/psf2022004031","DOIUrl":"https://doi.org/10.3390/psf2022004031","url":null,"abstract":": This paper presents a comprehensive study of the influence of various composite structure characteristics, such as stacking sequences and fiber orientations, on the dynamic behavior of glass fiber reinforced composite (GFRC) plates for modeling isolation and vibration control levels. The dynamic behavior of GFRCs with fiber volume fraction of 0.6 and fiber orientations of 0 ◦ , ± 35 ◦ , ± 45 ◦ , and 90 ◦ was investigated numerically using Solid works software, then verified experimentally using B&K data acquisition analyzer. The numerical and experimental results were presented and analyzed to obtain the optimum configuration for controlling vibration nature using the Taguchi technique. The results show that the lamina orientation of 0 ◦ had the dominant effect on natural frequencies, while 90 ◦ lamina orientation is the foremost factor in damping behavior.","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"21 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-09-13","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"132830102","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Review of Recent Achievements in Stress State Evaluation in Technical Element with Barkhausen Effect","authors":"B. Augustyniak, M. Chmielewski, L. Piotrowski","doi":"10.3390/psf2022004032","DOIUrl":"https://doi.org/10.3390/psf2022004032","url":null,"abstract":"","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"7 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-09-13","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"117178765","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
P. Lepitre, S. Calloch, M. Dhondt, M. Surand, C. Doudard
{"title":"Identification of the Damage Scenarios under Cyclic Loading of a Coated 300M Steel by Infrared Thermography Measurements","authors":"P. Lepitre, S. Calloch, M. Dhondt, M. Surand, C. Doudard","doi":"10.3390/psf2022004030","DOIUrl":"https://doi.org/10.3390/psf2022004030","url":null,"abstract":": An ultra-high-strength steel used in aeronautics for landing gears, 300M is generally shot-peened and coated with high-velocity oxygen fuel-sprayed WC-10Co-4Cr to improve its tribological behavior. In the literature, few treatment parameters have been tested to analyze the impacts on fatigue properties. Post-mortem optical microscopy has shown that the coating–substrate interface plays a key role in fatigue life, with new fracture scenarios having been observed compared to un-coated steel. To explore damage scenarios, infrared thermography measurements provide substantial information complementary to optical microscopy. The identification of damage scenarios is the first step in developing a lifespan forecast model.","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"50 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-09-05","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"125251631","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Characterising the Tensile Properties of Short Polyethylene Fibre and Bioactive Glass Reinforced Silicone Composite Skin Simulants","authors":"A. Chattrairat, R. Das, S. Aimmanee","doi":"10.3390/psf2022004029","DOIUrl":"https://doi.org/10.3390/psf2022004029","url":null,"abstract":"","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"56 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-08-29","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"126425863","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Influence of Transversal Connections on the Mechanical Behavior of 3D-Textile-Reinforced Cements (TRCs): Effect on Plate Specimens","authors":"M. El Kadi, D. Van Hemelrijck, T. Tysmans","doi":"10.3390/psf2022004028","DOIUrl":"https://doi.org/10.3390/psf2022004028","url":null,"abstract":"","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"43 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-08-19","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"127733040","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
Dimitrios Chantzis, Xiaochuan Liu, D. Politis, Liliang Wang
{"title":"Additive Manufacturing of Lattice Structured Hot Stamping Dies with Improved Thermal Performance","authors":"Dimitrios Chantzis, Xiaochuan Liu, D. Politis, Liliang Wang","doi":"10.3390/psf2022004025","DOIUrl":"https://doi.org/10.3390/psf2022004025","url":null,"abstract":"","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"19 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-08-18","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"133179050","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
A. Camacho‐Reyes, J. Vasco‐Olmo, E. López‐Alba, L. Felipe-Sesé, Á. Molina-Viedma, Juan-Antonio Almazán-Lázaro, F. Díaz
{"title":"Evaluation of the Effective Stress Intensity Factor Using Thermoelastic Stress Analysis and 2D Digital Image Correlation","authors":"A. Camacho‐Reyes, J. Vasco‐Olmo, E. López‐Alba, L. Felipe-Sesé, Á. Molina-Viedma, Juan-Antonio Almazán-Lázaro, F. Díaz","doi":"10.3390/psf2022004027","DOIUrl":"https://doi.org/10.3390/psf2022004027","url":null,"abstract":"","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"108 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-08-18","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"124158371","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Curvature Change in Laser-Assisted Bending of Inconel 718","authors":"J. Widłaszewski, M. Nowak, Z. Nowak, P. Kurp","doi":"10.3390/psf2022004026","DOIUrl":"https://doi.org/10.3390/psf2022004026","url":null,"abstract":"","PeriodicalId":237672,"journal":{"name":"The 19th International Conference on Experimental Mechanics","volume":"19 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"2022-08-18","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"127203038","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}