{"title":"Correlating Design Stresses and Fatigue Data for Propeller Alloys","authors":"M. Prager","doi":"10.5957/pss-1978-005","DOIUrl":"https://doi.org/10.5957/pss-1978-005","url":null,"abstract":"Calculating safe design stresses for propeller s using available fatigue data is discussed in detail. It is noted that no procedure can be rigorously justified because of the considerable number of factors influencing propeller strength and the inherent variability of large castings and corrosion fatigue tests. However, a method is proposed which avoids relying on precise knowledge of the properties of materials. Service experience is used to arrive at correlation coefficients which are needed to calculate allowable stresses over a range of operating conditions. The trends shown are believed to be reasonable. It is observed that the fatigue strengths of the propeller bronzes must be several times the nominal design stresses. In addition, it is suggested that the most reasonable projections occur when it is assumed that fatigue strength drops toward zero as the mean stress approaches the yield strength.","PeriodicalId":329029,"journal":{"name":"Day 1 Wed, May 24, 1978","volume":"48 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"1978-05-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"127725386","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Corrosion Fatigue of Cast Propeller Alloys","authors":"C. Jaske, D. Utah, W. K. Boyd","doi":"10.5957/pss-1978-003","DOIUrl":"https://doi.org/10.5957/pss-1978-003","url":null,"abstract":"The paper presents an outline of a new theoretical method for the calculation of the off-design performance characteristics of ducted propellers. The model for the duct performance calculation is an advanced non-linear model based on surface vorticity distribution techniques. The propeller model is a combination of principles postulated by momentum, blade-element and lifting line with lifting surface corrections theories of propeller action.\u0000 Results are presented of the application of the theory to the prediction of the performance analysis of a ducted propeller at two different coefficient of advance values. The results are compared with other theoretical and open water and tunnel experimental results for the propeller considered and the agreement found validates the concepts of the theory developed.","PeriodicalId":329029,"journal":{"name":"Day 1 Wed, May 24, 1978","volume":"149 5 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"1978-05-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"130818046","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Design of Machinery Test Model for Hydrodynamically Coupled Contra-Rotating Propellers","authors":"F. Dashnaw, D. Folenta","doi":"10.5957/pss-1978-001","DOIUrl":"https://doi.org/10.5957/pss-1978-001","url":null,"abstract":"The subject of contra-rotating propellers is now receiving more attention in the light of the increasing cost of marine fuels. There is nearly universal agreement that the use of contra-rotating propellers significantly improves propulsive efficiency. This work is part of a comprehensive program to establish the technical and economic merits of hydrodynamically coupled contra-rotating propellers via epicyclic gear as opposed to the more costly and complex alternate mechanically or thermodynamically coupled arrangements. This paper briefly describes the program and more specifically describes the model test rig that has been designed and constructed for use in the test and evaluation of two contra-rotating propeller designs as compared with the best available single propeller design operating on a selected model hull. The test rig will be used to generate performance data under various simulated operating conditions. Sketches, drawings, and other data depicting the test rig are included.","PeriodicalId":329029,"journal":{"name":"Day 1 Wed, May 24, 1978","volume":"67 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"1978-05-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"122254238","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Experimental Unsteady and Time-Average Loads on the Blades of a CP-Propeller Behind a Model of the DD 963","authors":"R. Boswell, S. Jessup, J. Nelka","doi":"10.5957/pss-1978-006","DOIUrl":"https://doi.org/10.5957/pss-1978-006","url":null,"abstract":"The time-average and unsteady loads were measured on a single blade of a model of the controllable-pitch propeller on the DD-963 Class Destroyer. The experiments were conducted behind a model of the DD-963 hull under steady ahead operation, hull pitching motions, and simulated acceleration manuevers.\u0000 The results show that all significant loads except radial force are predominantly of hydrodynamic origin. The circumferential variation of all measured components of blade loading is primarily a once-per-revolution variation, with the variation following approximately the variation of the tangential wake velocity.\u0000 The results show that unsteady loads are increased substantially by dynamic pitching of the model hull. For a simulated acceleration maneuver the circumferential variations of the loads are smaller than for full power steady ahead operation.\u0000 For steady ahead operation, circumferential variation of loading determined from the model experiments agreed fairly well with full-scale data, but was substantially larger than the theoretically calculated values.\u0000 For all conditions evaluated, the results follow close to previously published results of similar experiments on a model of the FF-1088.","PeriodicalId":329029,"journal":{"name":"Day 1 Wed, May 24, 1978","volume":"79 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"1978-05-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"132122884","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Development of Semi-Integrated Trunnion for Heavily Loaded CP Propeller Blade","authors":"M. Koyama, T. Mishima, F. Yamamoto","doi":"10.5957/pss-1978-007","DOIUrl":"https://doi.org/10.5957/pss-1978-007","url":null,"abstract":"CP-propeller is known to have the following disadvantages compared with FF-propeller.\u0000 1) Increased risk of root cavitation due to the restricted blade width at the root.\u0000 2) Parts with an increased number of notches are required to function under fluctuating loads in the un-uniform stern stream.\u0000 In order to solve these problems, we conducted 1) blade stress measurements with real ships, 2) static loading tests with model propellers, 3) blade bolt fatigue tests, and 4) propeller cavitation tests, and on the basis of the data obtained through these tests we worked out a new blade suspension system suited for large CPPs, which we named \"semi-integrated trunnion\" and, have put to practical use successfully. We have also demonstrated that with adoption of this semi-integrated trunnion the upper limit for the severity index for CPP design set by KHI on the basis of the past records can be raised substantially.","PeriodicalId":329029,"journal":{"name":"Day 1 Wed, May 24, 1978","volume":"18 1","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"1978-05-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"129244069","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Usefulness of Quasi-Steady Approach for Estimation of Propeller\u0000Bearing Forces","authors":"T. Sasajima","doi":"10.5957/pss-1978-009","DOIUrl":"https://doi.org/10.5957/pss-1978-009","url":null,"abstract":"Advantages of quasi-steady method in estimating propeller bearing forces are examined. It was found that the three-dimensional response of the propeller blade in sinusoidal gust is well predicted by the gust averaged a long the chord with weight f unction similar to the vortex distribution of a flat plate. Using this idea, a modified quasi-steady method for calculating propeller bearing forces was constructed. Comparison of the calculated results with model and full scale data showed good agreement and effectiveness of this met hod in practical application was shown.","PeriodicalId":329029,"journal":{"name":"Day 1 Wed, May 24, 1978","volume":"2 4","pages":"0"},"PeriodicalIF":0.0,"publicationDate":"1978-05-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"133136685","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":0,"RegionCategory":"","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}