{"title":"Evaluation of the constriction size reduction of granular filters due to upstream cohesive base-soil erosion","authors":"S. Azirou, A. Benamar, A. Tahakourt","doi":"10.18690/actageotechslov.15.1.29-41.2018","DOIUrl":"https://doi.org/10.18690/actageotechslov.15.1.29-41.2018","url":null,"abstract":"This study is devoted to filter-constrictions analysis and its application with respect to void and constrictions reduction during soil filtration. The experimental investigation involves combined Hole Erosion-Filtration tests using several soils and filters. The base soils are lean clays and the granular filters are selected according to the usual filtration criteria. The combination of the experimental data for porosity variation and the analytical results from the Constriction Size Distribution (CSD) analysis was used to evaluate the constrictions size reduction subsequent to the filtration process. The filtration depth was also estimated according to the retained soil mass and the porosity reduction deduced from the measured hydraulic conductivity. An analytical model of the CSD was applied to the experimental results in order to assess the constrictions reduction. As regards the obtained results, a non-uniform constriction reduction was suggested according to the effective filtration depth, advocating a dynamic filter action.","PeriodicalId":50897,"journal":{"name":"Acta Geotechnica Slovenica","volume":null,"pages":null},"PeriodicalIF":0.6,"publicationDate":"2018-06-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"46364081","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":4,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Effect of particle roundness and morphology on the shear failure mechanism of granular soil under strip footing","authors":"Babak Karimi Ghalehjough, S. Akbulut, S. Çelik","doi":"10.18690/ACTAGEOTECHSLOV.15.1.43-53.2018","DOIUrl":"https://doi.org/10.18690/ACTAGEOTECHSLOV.15.1.43-53.2018","url":null,"abstract":"This study investigates the effect of particles roundness and morphology on the shear failure mechanism of soil. A strip footing was modeled under laboratory conditions. Calcareous soil was tested with three roundness classes: angular, rounded and well-rounded shapes with sizes of 0.30 mm to 4.75 mm. These were divided into six different groups at three relative densities of 30%, 50% and 70%. A series of photographs was taken during the tests and analyzed using the particle image velocimetry (PIV) method to understand the soil-deformation mechanism. The results showed that increasing the sample sizes increased the affected area of the soil. At the same time, increasing the relative density caused a punching failure mechanism that went towards the general failure. The shear failure mechanism of the soil changed from general toward punching shear failure with increasing particle roundness. This effect was larger with the smaller materials. Underneath the affected layers of soil, the angular samples were deeper than the rounded and well-rounded samples. The affected depth in the angular soil was approximately 1.5B in the smallest size group. This was more than 3B and near 4B in the largest size group. Both the sides and the underlying soil layers should be considered on angular soils. The area under the footing becomes more important than the side parts after increasing the roundness of the particles.","PeriodicalId":50897,"journal":{"name":"Acta Geotechnica Slovenica","volume":null,"pages":null},"PeriodicalIF":0.6,"publicationDate":"2018-06-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"41931295","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":4,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Critical setback distance for a footing resting on slopes","authors":"Rajesh Prashad Shukla, R. Jakka","doi":"10.12989/GAE.2018.15.6.1193","DOIUrl":"https://doi.org/10.12989/GAE.2018.15.6.1193","url":null,"abstract":"Structures are often constructed on slopes in hilly regions, which results in a lack of soil support on the sloping side of the footings. This causes a reduction in the bearing capacity of the footings. Though there are number of studies about foundations on slopes, most of these studies are confined to surface footings only (i.e., without the depth of embedment). Furthermore, there is no consensus in the literature over the influence of the setback distance on bearing capacity. This paper presents the results of finite-element analyses on a strip footing resting on stable slopes. A very large number of possible soil slopes with different footing depths were analysed. From the results it is found that the critical setback distance increases with an increase in the internal friction angle of soil, the depth of the footing and the slope gradient. The critical setback distance is varying between 2 to 4 times the footing width for soils with a low internal friction angle, while it is more than 10 times the footing width for soils with a higher internal friction angle. A regression equation is also developed based on the outcomes of the study. The developed equation is able to predict the influence of various parameters affecting the bearing capacity of a footing resting over the slopes. The results are compared with earlier experimental and numerical studies.","PeriodicalId":50897,"journal":{"name":"Acta Geotechnica Slovenica","volume":null,"pages":null},"PeriodicalIF":0.6,"publicationDate":"2017-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"66452241","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":4,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
{"title":"Investigation of the end bearing load in pile group model in dry soil under horizontal excitation","authors":"M. Fattah, H. Karim, M. Al-Recaby","doi":"10.18690/actageotechslov.18.1.79-106.2021","DOIUrl":"https://doi.org/10.18690/actageotechslov.18.1.79-106.2021","url":null,"abstract":"A series of 94 laboratory tests were conducted to measure the response of pile foundation when subjected to dynamic loads. Eight tests were conducted on single pile in dry soil at relative density 30 % (loose) and 50 % (medium); 66 tests on group of piles with different spacings and patterns. All tests were carried out under operating frequencies 0.5, 1 and 2 Hz under horizontal shaking. All tests were achieved with one embedment ratio (L/d = 30). These tests were grouped in three different numbers of piles; 2 piles in row and line patterns, 3 piles and 4 piles; and three pile spacing ratios (s/d = 3, 4 and 5).\u0000The results of dry soil indicating the mechanism of dynamic response of piles and soil subjected to dynamic horizontal shaking include the variation and distribution of acceleration with time in different states of soil in addition to the vertical and horizontal displacements, end-bearing load, peak acceleration and the peak velocity of foundation.\u0000It was concluded that for a dry soil bed, the acceleration amplitudes increase with frequency for both soil relative densities (loose and medium) and different pile patterns\u0000(number; single or group and different spacing ratios s/d). The maximum acceleration in the foundation is lower than in the soil bed for all operating shaking frequencies, pile spacing ratios and soil states. The decreasing of the maximum acceleration recorded in the foundation as compared to that in the soil bed is between 10-100 % for loose and medium state of soil, and the decrease in loose state is more than in medium state. This means that there is damping effect or attenuation of vibration waves. The amplitudes of recorded acceleration in the pile cap are much higher than in the soil bed for single pile and pile group with different pile spacing ratios, also these amplitudes are increasing with increase of shaking frequency and relative density of the soil.","PeriodicalId":50897,"journal":{"name":"Acta Geotechnica Slovenica","volume":null,"pages":null},"PeriodicalIF":0.6,"publicationDate":"1900-01-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":null,"resultStr":null,"platform":"Semanticscholar","paperid":"67766863","PeriodicalName":null,"FirstCategoryId":null,"ListUrlMain":null,"RegionNum":4,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":"","EPubDate":null,"PubModel":null,"JCR":null,"JCRName":null,"Score":null,"Total":0}
求助内容：
应助结果提醒方式：
京公网安备 11010802042870号
