Computer‐aided selective production of low-resistance NiP and NiCuP layers

Purpose This paper aims to present the possibility of computer-aided technology of chemical metallization for the production of electrodes and resistors based on Ni-P and Ni-Cu-P layers. Design/methodology/approach Based on the calculated parameters of the process, test structures were made on an alumina substrate using the selective metallization method. Dependences of the surface resistance on the metallization time were made. These dependencies take into account the comparison of the calculations with the performed experiment. Findings The author created a convenient and easy-to-use tool for calculating basic Ni-P and Ni-Cu-P layer parameters, namely, surface resistance and temperature coefficient of resistance (TCR) of test resistor, based on chemical metallization parameters. The values are calculated for a given level of surface resistance of Ni-P and Ni-Cu-P layer and defined required range of changes of TCR of test resistor. The calculations are possible for surface resistance values in the range of 0.4 Ohm/square ÷ 2.5 Ohm/square. As a result of the experiment, surface resistances were obtained that practically coincide with the calculations made with the use of the program created by the authors. The quality of the structures made is very good. Originality/value To the best of the authors’ knowledge, the paper presents a new, unpublished method of manufacturing electrodes (resistors) on silicon, Al2O3 and low temperature co-fired ceramic substrates based on the authors developed computer program.