Application of a method for characterization of thermo mechanical stress caused by packaging processes

Abstract

This paper reports on a method for the investigation of mechanical stress on MEMS sensor and actuator structures due to packaging processes. A silicon test chip is developed and manufactured to validate the simulation results. Finite element analysis (FEA) is used to optimize the geometric parameters and to find a stress sensitive sensor geometry. A diaphragm structure is used as mechanical amplifier for bulk induced stresses during the packaging process. Piezo resistive solid state resistors are doped into the surface of the chip to measure the stress in the diaphragms and at the contact pads being most significant locations for analysis. A high precision ohmmeter was used to measure the resistance prior and past the packaging process. The captured data allows for computation of the resulting stress loads in magnitude. Therefore, a stress evaluation of different packaging technologies is conducted and the impact of the packaging process on reliability can be estimated immediately.