Role of additives and surface passivation on the performance of perovskite solar cells

Outstanding improvement in power conversion efficiency (PCE) over 25% in a very short period and promising research developments to reach the theoretical PCE limit of single junction solar cells, 33%, enables organic–inorganic perovskite solar cells (OIPSCs) to gain much attention in the scientific and industrial community. The simplicity of production of OIPSCs from precursor solution either on rigid or flexible substrates makes them even more attractive for low-cost roll-to-roll production processes. Though OIPSCs show as such higher PCE with simple solution processing methods, there are still unresolved issues, while attempts are made to commercialize these solar cells. Among the major problems is the instability of the photoactive layer of OIPSCs at the interface of the charge transport layers and /or electrodes during prolonged exposure to moisture, heat and radiation. To achieve matched PCE and stability, several techniques such as molecular and interfacial engineering of components in OIPSCs have been applied. Moreover, in recent times, engineering on additives, solvents, surface passivation, and structural tuning have been developed to reduce defects and large grain boundaries from the surface and/or interface of organic–inorganic perovskite films. Under this review, we have shown recently developed additives and passivation strategies, which are strongly focused to enhance PCE and long-term stability simultaneously.