Experimental study on co-firing characteristics of ammonia with pulverized coal in a staged combustion drop tube furnace

Utilizing ammonia as a co-firing fuel to replace amounts of fossil fuel seems a feasible solution to reduce carbon emissions in existing pulverized coal-fired power plants. However, there are some problems needed to be considered when treating ammonia as a fuel, such as low flame stability, low combustion efficiency, and high NO_x emission. In this study, the co-firing characteristics of ammonia with pulverized coal are studied in a drop tube furnace with staged combustion strategy. Results showed that staged combustion would play a key role in reducing NO_x emissions by reducing the production of char-NO_x and fuel(NH₃)-NO_x simultaneously. Furthermore, the effects of different ammonia co-firing methods on the flue gas properties and unburned carbon contents were compared to achieve both efficient combustion and low NO_x emission. It was found that when ammonia was injected into 300 mm downstream under the condition of 20% co-firing, lower NO_x emission and unburnt carbon content than those of pure coal combustion can be achieved. This is probably caused by a combined effect of a high local equivalence ratio of NH₃/air and the prominent denitration effect of NH₃ in the vicinity of the NH₃ downstream injection location. In addition, NO_x emissions can be kept at approximately the same level as coal combustion when the co-firing ratio is below 30%. And the influence of reaction temperature on NO_x emissions is closely associated with the denitration efficiency of the NH₃. Almost no ammonia slip has been detected for any injection methods and co-firing ratio in the studied conditions. Thus, it can be confirmed that ammonia can be used as an alternative fuel to realize CO₂ reduction without extensive retrofitting works. And the NO_x emission can be reduced by producing a locally NH₃ flame zone with a high equivalence ratio as well as ensuring adequate residence time.