Selective leaching and solvent extraction of Lithium from spent batteries

Pre-extracting Li from spent lithium-ion batteries (LIBs) is crucial because the recovery efficiency of Li is low after other critical metals have been extracted. Traditional methods involving black mass roasting followed by water leaching have resulted in the extraction of 76 % Li and 61 % Al. However, pre-leaching Li from pretreated black mass using an oxalic acid solution at both ambient and elevated temperatures significantly improved results, achieving 98.1 % Li, 99.5 % Al, and 100 % Fe extraction while leaving Ni, Co, Mn, and Cu behind under optimal conditions. Oxalic acid crystals were recovered by refrigerating the leach solution at temperatures below 5 °C and were reused with nearly identical leaching efficiency. Selective extraction of Li from the oxalate leach solution was achieved using Cyanex® 936P under optimal conditions. Due to its extremely low Li extraction efficiency, Dichloromethane proved unsuitable as a diluent. Comparative extraction tests using Cyanex® 936P, Cyanex® 272, and DEHPA in kerosene demonstrated that Cyanex® 936P is an excellent extractant for Li, effectively separating it from other impurities. Under optimal conditions, 98.8 % of available Li was extracted using 20 % Cyanex® 936P, compared to 51.1 % with Cyanex® 272 and 39.9 % with DEHPA in kerosene. Additionally, stripping Li from Cyanex® 936P using H₂SO₄ and HCl was explored, with HCl yielding the best performance.