Fracture Behavior of Hardfacing Alloy Coated Over Stainless Steel under Quasi-Static and Dynamic Loads

The fracture behavior of bi-material made of Ni-Cr-B-Si hardfacing alloy deposited over SS316LN substrate was evaluated under quasi-static and dynamic loads. The crack growth started from notch made on the deposit side and progress toward the substrate deposit interface under both loading conditions was monitored. The displacement rate in quasi-static loading and the loading rate for dynamic loading varied and crack propagation was studied. It was observed that the crack was deflected at the interface and not penetrated to the substrate, irrespective of loading conditions. The reason for crack deflection at the interface was analyzed using the energy-based method. It is shown that the ratio of fracture toughness of the interface to that of the substrate (0.044) is lower than the ratio of energy release rate for the deflecting crack to that of the penetrating crack (0.235). Thus, this material combination satisfies the condition for crack deflection rather than penetration. The fracture toughness of the interface was estimated as ~ 68 MPa m^1/2 and it falls between that of hardfacing alloy and SS316LN base metal. Optical and SEM examinations were conducted to corroborate the crack path deviations during crack growth. Results suggest that isolated cracks might be present on hardfaced coatings on critical components for which such cracks are usually not permitted. It may be allowed in preference to repair of these cracks, which is difficult and significantly increases the risk of additional cracks forming on the deposits because of the high susceptibility of the hardfacing alloy to cracking.