The Impact of Modeling Liquids on Surface Roughness and Color Properties of Bulkfill Resin Composites After Simulated Tooth Brushing: An in Vitro Study. Part I

ObjectiveTo evaluate the effect of different modeling agents on color changes, surface roughness, and translucency parameters over time in Bulkfill resin composites.Material and MethodsSixty specimens were prepared using three Bulkfill resin composites (Tetric N‐Ceram Bulkfill, Filtek One Bulkfill and Opus Bulkfill) and three modeling agents (Wetting Resin, Optibond FL and Ambar APS). All specimens were subjected to a simulated tooth‐brushing (Baseline, 50.000 cycles, 100.000 cycles), and surface roughness was measured at each interval. Surface topography was evaluated. The translucency parameter and color changes were assessed after 24‐h, 7‐, 14‐ and 30‐day immersion in water, wine, and coffee. Data was analyzed using ANOVA and Bonferroni test.ResultsAll specimens increased roughness after simulated tooth‐brushing (p < 0.05). Wetting Resin decreased roughness on Tetric N‐Ceram Bulkfill (p < 0.05). The translucency parameter remained unaltered for all groups. All groups changed color after 30‐days of immersion in wine and coffee (p < 0.05). Ambar APS and Wetting Resin on Tetric N‐Ceram Bulkfill showed higher color changes when immersed in coffee (p < 0.05).ConclusionThe use of modeling agents does not jeopardize translucency properties but may affect surface roughness and color properties of Bulkfill resin composites depending on their composition.Clinical SignificanceThe findings of this study suggest that surface roughness and color properties are affected by the differences in the composition between modeling agents and Bulkfill resins composites.