Jie Wang, Dan Huang, Xiaowei Kong, Xuepeng Jiang, Kaihua Lu
{"title":"水喷雾对对称 V 形隧道中火灾烟雾分层的影响","authors":"Jie Wang, Dan Huang, Xiaowei Kong, Xuepeng Jiang, Kaihua Lu","doi":"10.1007/s10694-024-01648-z","DOIUrl":null,"url":null,"abstract":"<p>Smoke stratification in a V-shaped tunnel fire is complex due to the coupling effects of the double stack effect induced by the inclined tunnel structure, the fire thermal buoyancy, and the drag force caused by water spray system. This work investigates the influence of water spray flow rate (0 L/min to 600 L/min), atomization angle (0° to 150°) and distance between fire source and grade change point (0 m to 120 m) on smoke stratification in a symmetrical V-shaped tunnel through numerical simulations. The results show that the increase of water spray flow rate causes the increasing drag force which destabilizes smoke layer and contributes to the reduction of smoke layer thickness. While the water spray angle has little effect on smoke layer thickness. Through the dimensionless analysis and simulation results, a correlation for smoke layer thickness considering water spray parameters is proposed. Water spray effects on <i>Fr</i> describing the smoke stratification correspond to these on smoke layer thickness. That is, <i>Fr</i> decreases with the increase of water spray flow rate and is weak dependent on the water spray angle, and the critical <i>Fr</i> for turning point of the dominant effect of thermal buoyancy and drag force is linearly related to fire heat release rate. As the distance between fire source and grade change point increases, <i>Fr</i> changes a little on first double-slope control stage, increases on the left and decreases on the right of fire source, and eventually both levels off on second transition phase stage, thus tends to be stable on third single slope control stage.</p>","PeriodicalId":558,"journal":{"name":"Fire Technology","volume":"22 1","pages":""},"PeriodicalIF":2.3000,"publicationDate":"2024-09-14","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":"{\"title\":\"Water Spray Effects on Fire Smoke Stratification in a Symmetrical V-Shaped Tunnel\",\"authors\":\"Jie Wang, Dan Huang, Xiaowei Kong, Xuepeng Jiang, Kaihua Lu\",\"doi\":\"10.1007/s10694-024-01648-z\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"<p>Smoke stratification in a V-shaped tunnel fire is complex due to the coupling effects of the double stack effect induced by the inclined tunnel structure, the fire thermal buoyancy, and the drag force caused by water spray system. This work investigates the influence of water spray flow rate (0 L/min to 600 L/min), atomization angle (0° to 150°) and distance between fire source and grade change point (0 m to 120 m) on smoke stratification in a symmetrical V-shaped tunnel through numerical simulations. The results show that the increase of water spray flow rate causes the increasing drag force which destabilizes smoke layer and contributes to the reduction of smoke layer thickness. While the water spray angle has little effect on smoke layer thickness. Through the dimensionless analysis and simulation results, a correlation for smoke layer thickness considering water spray parameters is proposed. Water spray effects on <i>Fr</i> describing the smoke stratification correspond to these on smoke layer thickness. That is, <i>Fr</i> decreases with the increase of water spray flow rate and is weak dependent on the water spray angle, and the critical <i>Fr</i> for turning point of the dominant effect of thermal buoyancy and drag force is linearly related to fire heat release rate. As the distance between fire source and grade change point increases, <i>Fr</i> changes a little on first double-slope control stage, increases on the left and decreases on the right of fire source, and eventually both levels off on second transition phase stage, thus tends to be stable on third single slope control stage.</p>\",\"PeriodicalId\":558,\"journal\":{\"name\":\"Fire Technology\",\"volume\":\"22 1\",\"pages\":\"\"},\"PeriodicalIF\":2.3000,\"publicationDate\":\"2024-09-14\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"Fire Technology\",\"FirstCategoryId\":\"5\",\"ListUrlMain\":\"https://doi.org/10.1007/s10694-024-01648-z\",\"RegionNum\":3,\"RegionCategory\":\"工程技术\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q2\",\"JCRName\":\"ENGINEERING, MULTIDISCIPLINARY\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"Fire Technology","FirstCategoryId":"5","ListUrlMain":"https://doi.org/10.1007/s10694-024-01648-z","RegionNum":3,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q2","JCRName":"ENGINEERING, MULTIDISCIPLINARY","Score":null,"Total":0}
引用次数: 0
摘要
V 型隧道火灾中的烟雾分层非常复杂,这主要是由于倾斜隧道结构引起的双堆效应、火灾热浮力和喷水系统引起的阻力的耦合效应造成的。本研究通过数值模拟研究了喷水流量(0 L/min 至 600 L/min)、雾化角度(0° 至 150°)以及火源与坡度变化点之间的距离(0 m 至 120 m)对对称 V 型隧道内烟雾分层的影响。结果表明,喷水流速的增加会导致阻力增大,从而破坏烟层的稳定性,并导致烟层厚度的减少。而喷水角度对烟雾层厚度的影响很小。通过无量纲分析和模拟结果,提出了考虑喷水参数的烟层厚度相关性。水雾对描述烟雾分层的 Fr 的影响与对烟雾层厚度的影响相对应。也就是说,Fr 随喷水流量的增加而减小,且与喷水角度的依赖性较弱,热浮力和阻力主导效应转折点的临界 Fr 与火灾热释放率呈线性关系。随着火源与坡度变化点之间距离的增加,Fr 在第一个双坡控制阶段变化不大,在火源左侧增大,右侧减小,最终在第二个过渡阶段均趋于平稳,从而在第三个单坡控制阶段趋于稳定。
Water Spray Effects on Fire Smoke Stratification in a Symmetrical V-Shaped Tunnel
Smoke stratification in a V-shaped tunnel fire is complex due to the coupling effects of the double stack effect induced by the inclined tunnel structure, the fire thermal buoyancy, and the drag force caused by water spray system. This work investigates the influence of water spray flow rate (0 L/min to 600 L/min), atomization angle (0° to 150°) and distance between fire source and grade change point (0 m to 120 m) on smoke stratification in a symmetrical V-shaped tunnel through numerical simulations. The results show that the increase of water spray flow rate causes the increasing drag force which destabilizes smoke layer and contributes to the reduction of smoke layer thickness. While the water spray angle has little effect on smoke layer thickness. Through the dimensionless analysis and simulation results, a correlation for smoke layer thickness considering water spray parameters is proposed. Water spray effects on Fr describing the smoke stratification correspond to these on smoke layer thickness. That is, Fr decreases with the increase of water spray flow rate and is weak dependent on the water spray angle, and the critical Fr for turning point of the dominant effect of thermal buoyancy and drag force is linearly related to fire heat release rate. As the distance between fire source and grade change point increases, Fr changes a little on first double-slope control stage, increases on the left and decreases on the right of fire source, and eventually both levels off on second transition phase stage, thus tends to be stable on third single slope control stage.
期刊介绍:
Fire Technology publishes original contributions, both theoretical and empirical, that contribute to the solution of problems in fire safety science and engineering. It is the leading journal in the field, publishing applied research dealing with the full range of actual and potential fire hazards facing humans and the environment. It covers the entire domain of fire safety science and engineering problems relevant in industrial, operational, cultural, and environmental applications, including modeling, testing, detection, suppression, human behavior, wildfires, structures, and risk analysis.
The aim of Fire Technology is to push forward the frontiers of knowledge and technology by encouraging interdisciplinary communication of significant technical developments in fire protection and subjects of scientific interest to the fire protection community at large.
It is published in conjunction with the National Fire Protection Association (NFPA) and the Society of Fire Protection Engineers (SFPE). The mission of NFPA is to help save lives and reduce loss with information, knowledge, and passion. The mission of SFPE is advancing the science and practice of fire protection engineering internationally.