Graphene nanoplatelet reinforced Al-based composites prepared from recycled powders via mechanical alloying and pressureless sintering

This study reports on the powder metallurgy preparation and characterization of aluminum-graphene nanoplatelet (Al-GNP) composites synthesized using recycled Al powders. Recycled Al and GNP powders (0.1–1 wt%) were mechanically alloyed (MA'd) for 4 h, followed by cold pressing (at 450 MPa) and pressureless sintering at 590 °C for 2 h. Starting powders were analyzed using an optical emission spectrometer (OES) and a Raman spectrometer. Also, MA'd powders and sintered samples were characterized using an X-ray diffractometer (XRD), a scanning electron microscope/energy dispersive spectrometer (SEM/EDS), and a differential scanning calorimeter (DSC). Particle size analyses, pycnometer, and Archimedes' densities, Vickers microhardness, dry-sliding wear, and compression tests were also conducted. The Al₄C₃ formation was observed in the XRD patterns of sintered compositions. The highest and lowest relative densities were measured for the 1 wt% and 0.1 wt% GNP reinforced samples as 97 % and 92 %, respectively. The highest hardness value was obtained as approximately 1.31 GPa for 1 wt% GNP reinforced. With the addition of reinforcement GNP, the wear rate developed to approximately 0.00225 mm³/Nm. The compressive strength increased from nearly 70 MPa to 162 MPa.