Preparation of calcium aluminate and spinel by hydrolysis and calcination from secondary aluminum dross

The direct extraction of alumina from secondary aluminum dross (SAD), which is a dangerous solid waste, is difficult. Moreover, this process easily produces a large amount of solid waste residue, which is not easily utilized. In this paper, a new green process was developed to prepare calcium aluminate and Mg‐Al spinel from SAD by hydrolysis–calcification roasting. The effects of calcium oxide (CaO) content, sintering temperature, and holding time on the properties of calcium aluminate were investigated by single‐factor experiments. The phase transformation mechanism of calcium aluminate was studied by thermodynamic analysis, X‐ray diffraction analysis, X‐ray fluorescence spectroscopy, and scanning electron microscopy. Under the optimal conditions (Ca/Al molar ratio of 0.8, sintering temperature of 1300°C, and holding time of 2 h), the main calcium aluminate phases are CaAl2O4 and Ca2Al2SiO7, the soluble alumina content of the calcium aluminate sample is 49.71 wt.%, and the main phases of the acid‐insoluble residue are Mg‐Al spinel and a very small amount of CaTiO3. The Ca/Al ratio is the key factor affecting the calcium aluminate phase—with increasing Ca/Al ratio, the calcium aluminate phase is transformed from CaAl4O7 to CaAl2O4 and eventually to Ca12Al14O33, and the Si‐containing phase changes from Ca2Al2SiO7 to CaSiO4.