Enhancing prosthesis stability at the cricoid cartilage in equine laryngoplasty using 3-D-printed laryngeal clamps: An ex vivo model study.

Objective: To assess a three-dimensional (3-D)-printed laryngeal clamp (LC) designed to enhance the anchoring of laryngeal prostheses at the cricoid cartilage.

Study design: Ex vivo biomechanical study.

Sample population: A total of 22 equine larynges.

Methods: Two experimental groups included larynges with standard prosthetic laryngoplasty (PL; n = 10) and larynges with prosthetic laryngoplasty modified with laryngeal clamps (PLLC; n = 10). All constructs underwent 3000 cycles of tension loading and a single tension to failure. Recorded biomechanical parameters included maximum load, actuator displacement, and construct failure. Finite element analysis (FEA) was performed on one PL and one PLLC construct.

Results: The maximum load at single tension to failure was 183.7 ± 46.8 N for the PL construct and 292.7 ± 82.3 N for the PLLC construct (p = .003). Actuator displacement at 30 N was 1.7 ± 0.5 mm and 2.7 ± 0.7 mm for the PL and PLLC constructs, respectively (p = .011). The cause of PL constructs failure was mostly tearing through the cartilage whereas the PLLC constructs failed through fracture of the cricoid cartilage (p = .000). FEA revealed an 11-fold reduction in the maximum equivalent plastic strain, a four-fold reduction in maximum compressive stress, and a two-fold increase in the volume of engaged cartilage in PLLC constructs.

Conclusion: The PLLC constructs demonstrated superior performance in biomechanical testing and FEA compared to standard PL constructs.

Clinical significance: The use of 3-D-printed laryngeal clamps may enhance the outcomes of laryngoplasty in horses. In vivo studies are necessary to determine the feasibility of performing laryngoplasty using the laryngeal clamp in horses.