{"title":"轮胎磨损颗粒对全湿范围内不同质地土壤保水性的影响","authors":"Amir Verdi , Mahyar Naseri","doi":"10.1016/j.jconhyd.2024.104345","DOIUrl":null,"url":null,"abstract":"<div><p>Tire wear particles (TWPs) are significant contributors to microplastic pollution in the environment, yet there is limited scientific information concerning their impact on soil hydraulic properties. This study aimed to investigate the impact of TWPs at different concentrations (1, 4, 8, and 16% of the air-dried mass of packed soil samples, w/w) on the water retention curves (WRC) of southern California soils with five different textures (clay, clay loam, silt loam, sandy loam, and loamy sand). The concentrations of 8% and 16% were selected to represent extreme pollution scenarios that might occur near highway corridors. High-resolution water retention data, spanning from saturation to oven dryness, were generated using HYPROP™ and WP4C dew point meter instruments. We also developed WRC scaling equations based on the quantity of TWPs. The bulk density of the samples decreased as the TWP concentration in soils increased. The inclusion of very high concentrations of TWPs (8% and 16% w/w) led to a significant reduction in soil moisture content in the intermediate and dry ranges across various soil textures. However, at the same moisture range, adding 1% TWPs had a minimal impact on soil moisture reduction, while the influence of the 4% TWPs concentration treatment was noticeable only in loamy sand and partially in clay loam soils. Additionally, the overall plant available water decreased with increasing TWP concentrations, except for the clay soil. The texture-specific scaling models exhibited promising performance, with RMSE values ranging from 0.0061 to 0.0120 cm<sup>3</sup> cm<sup>−3</sup>. When bulk density was included as an additional input predictor to construct a single scaling model for all textures, the RMSE increased. Nevertheless, it still indicated a good fit ranging from 0.007 to 0.024 cm<sup>3</sup> cm<sup>−3</sup>, highlighting the suitability of simple scaling for identifying WRC in TWPs-polluted soils, particularly for practical purposes. The findings of this study can contribute to a better understanding and quantification of the impact of TWPs on soil hydrology.</p></div>","PeriodicalId":3,"journal":{"name":"ACS Applied Electronic Materials","volume":null,"pages":null},"PeriodicalIF":4.3000,"publicationDate":"2024-04-18","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://www.sciencedirect.com/science/article/pii/S0169772224000494/pdfft?md5=4a3b9d1541243a3cde86f77cdd32e482&pid=1-s2.0-S0169772224000494-main.pdf","citationCount":"0","resultStr":"{\"title\":\"Effects of tire wear particles on the water retention of soils with different textures in the full moisture range\",\"authors\":\"Amir Verdi , Mahyar Naseri\",\"doi\":\"10.1016/j.jconhyd.2024.104345\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"<div><p>Tire wear particles (TWPs) are significant contributors to microplastic pollution in the environment, yet there is limited scientific information concerning their impact on soil hydraulic properties. This study aimed to investigate the impact of TWPs at different concentrations (1, 4, 8, and 16% of the air-dried mass of packed soil samples, w/w) on the water retention curves (WRC) of southern California soils with five different textures (clay, clay loam, silt loam, sandy loam, and loamy sand). The concentrations of 8% and 16% were selected to represent extreme pollution scenarios that might occur near highway corridors. High-resolution water retention data, spanning from saturation to oven dryness, were generated using HYPROP™ and WP4C dew point meter instruments. We also developed WRC scaling equations based on the quantity of TWPs. The bulk density of the samples decreased as the TWP concentration in soils increased. The inclusion of very high concentrations of TWPs (8% and 16% w/w) led to a significant reduction in soil moisture content in the intermediate and dry ranges across various soil textures. However, at the same moisture range, adding 1% TWPs had a minimal impact on soil moisture reduction, while the influence of the 4% TWPs concentration treatment was noticeable only in loamy sand and partially in clay loam soils. Additionally, the overall plant available water decreased with increasing TWP concentrations, except for the clay soil. The texture-specific scaling models exhibited promising performance, with RMSE values ranging from 0.0061 to 0.0120 cm<sup>3</sup> cm<sup>−3</sup>. When bulk density was included as an additional input predictor to construct a single scaling model for all textures, the RMSE increased. Nevertheless, it still indicated a good fit ranging from 0.007 to 0.024 cm<sup>3</sup> cm<sup>−3</sup>, highlighting the suitability of simple scaling for identifying WRC in TWPs-polluted soils, particularly for practical purposes. The findings of this study can contribute to a better understanding and quantification of the impact of TWPs on soil hydrology.</p></div>\",\"PeriodicalId\":3,\"journal\":{\"name\":\"ACS Applied Electronic Materials\",\"volume\":null,\"pages\":null},\"PeriodicalIF\":4.3000,\"publicationDate\":\"2024-04-18\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"https://www.sciencedirect.com/science/article/pii/S0169772224000494/pdfft?md5=4a3b9d1541243a3cde86f77cdd32e482&pid=1-s2.0-S0169772224000494-main.pdf\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"ACS Applied Electronic Materials\",\"FirstCategoryId\":\"93\",\"ListUrlMain\":\"https://www.sciencedirect.com/science/article/pii/S0169772224000494\",\"RegionNum\":3,\"RegionCategory\":\"材料科学\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q1\",\"JCRName\":\"ENGINEERING, ELECTRICAL & ELECTRONIC\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"ACS Applied Electronic Materials","FirstCategoryId":"93","ListUrlMain":"https://www.sciencedirect.com/science/article/pii/S0169772224000494","RegionNum":3,"RegionCategory":"材料科学","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q1","JCRName":"ENGINEERING, ELECTRICAL & ELECTRONIC","Score":null,"Total":0}
Effects of tire wear particles on the water retention of soils with different textures in the full moisture range
Tire wear particles (TWPs) are significant contributors to microplastic pollution in the environment, yet there is limited scientific information concerning their impact on soil hydraulic properties. This study aimed to investigate the impact of TWPs at different concentrations (1, 4, 8, and 16% of the air-dried mass of packed soil samples, w/w) on the water retention curves (WRC) of southern California soils with five different textures (clay, clay loam, silt loam, sandy loam, and loamy sand). The concentrations of 8% and 16% were selected to represent extreme pollution scenarios that might occur near highway corridors. High-resolution water retention data, spanning from saturation to oven dryness, were generated using HYPROP™ and WP4C dew point meter instruments. We also developed WRC scaling equations based on the quantity of TWPs. The bulk density of the samples decreased as the TWP concentration in soils increased. The inclusion of very high concentrations of TWPs (8% and 16% w/w) led to a significant reduction in soil moisture content in the intermediate and dry ranges across various soil textures. However, at the same moisture range, adding 1% TWPs had a minimal impact on soil moisture reduction, while the influence of the 4% TWPs concentration treatment was noticeable only in loamy sand and partially in clay loam soils. Additionally, the overall plant available water decreased with increasing TWP concentrations, except for the clay soil. The texture-specific scaling models exhibited promising performance, with RMSE values ranging from 0.0061 to 0.0120 cm3 cm−3. When bulk density was included as an additional input predictor to construct a single scaling model for all textures, the RMSE increased. Nevertheless, it still indicated a good fit ranging from 0.007 to 0.024 cm3 cm−3, highlighting the suitability of simple scaling for identifying WRC in TWPs-polluted soils, particularly for practical purposes. The findings of this study can contribute to a better understanding and quantification of the impact of TWPs on soil hydrology.