Defects Imaging in Corner Part with Surface Adaptive Ultrasonic and Focusing in Receiving (FiR) Strategy

A weak circumferential resolution of defects in the corner part of engineering components brings great challenges to quantitative non-destructive testing. Especially for the corner of carbon fiber reinforced plastics (CFRP), the complex wave propagation behaviors caused by the elastic anisotropy, laminate structure, and curved surface make the information of defects hard to be distinguished, which finally results in a poor imaging resolution. The surface adaptive ultrasonic (SAUL) method for CFRP corner is investigated, and an improved strategy, focusing in receiving (FiR) of SAUL signals is proposed here. With an isotropic plexiglass as a comparison, the effectiveness of FiR is verified by finite element simulations and experiments. The elastic properties of CFRP corner are accurately characterized and a finite element model is established. On this basis, the wave propagation behavior in the corner is studied, and the influence of the water distance h on the maximum amplitude (MAD) and signal-to-noise ratio (SNR) at the defect is analyzed. The results show that the structural noise can be eliminated, and the imaging quality and SNR can be improved by optimizing the h. After FiR, the maximum increase of defect amplitude is about 9.5 dB and 13.2 dB for plexiglass and CFRP, respectively. Meanwhile, the maximum relative error in length is reduced by 16.7% in plexiglass, and by 13.4% for the 3-mm delamination in CFRP. The strategy would be promising to improve the detection quality of the corner in curved components.