碳纤维表面改性对 SiO2 涂层形成的影响

IF 0.6 4区 化学 Q4 CHEMISTRY, APPLIED
R. F. Gallyamova, S. A. Grabovskiy, V. A. Dokichev, F. F Musin
{"title":"碳纤维表面改性对 SiO2 涂层形成的影响","authors":"R. F. Gallyamova,&nbsp;S. A. Grabovskiy,&nbsp;V. A. Dokichev,&nbsp;F. F Musin","doi":"10.1134/S1070427223050142","DOIUrl":null,"url":null,"abstract":"<p>Surface modification of carbon fiber with 1,1-dihydroperoxycyclohexane (DHPC) before application of SiO<sub>2</sub> barrier coating was studied. IR spectroscopy showed presence of the COOH carboxyl groups on the surface of modified carbon fibers. The modified surface has less hydrophobicity due to the presence of polar groups, which contribute to a change in the wettability of the fiber by the sol–gel solution and the adhesion of the oxide coating to the fiber surface. The quality and thickness of the oxide coatings were assessed by scanning electron microscopy. The use of DHPC leads to oxidation of the carbon fiber, making surface longitudinal stripes deeper. To determine the effect of DHPC modification on the properties of the fiber surface, a SiO<sub>2</sub> coating was applied by immersion in a tetraethoxysilane sol. DHPC modification leads to the formation of a uniform SiO<sub>2</sub> coating on the fiber surface. After the heat treatment, the coating thickness on the DHPC–modified fibers is 130 ± 30 nm. Analysis of the IR spectra showed that the addition of DHPC to the sol leads to an increase in the intensity of the Si–O–Si, Si–OH, and OH absorption bands, which are characteristic of the hydrolysis and polycondensation products of tetraethoxysilane. In the wavenumber range of 400–1200 cm<sup>–1</sup>, the Si–O–Si fragments form, which is confirmed by the presence of bands of Si–O– deformation bond at ν = 881 and 442 cm<sup>–1</sup>. The introduction of DHPC into the sol promotes the formation of a uniform coating on the carbon fibers. The coating thickness on the initial fibers reaches 410±100 nm at room temperature, decreasing to 190±60 nm after heating. The fiber and sol modification contribute to formation of a uniform coating with a thickness of 200 ± 70 nm and 130 ± 30 nm before and after the heating, respectively. DHPC modification of the fiber surface and tetraethoxysilane sol promotes the formation of continuous, uniform, and quality SiO<sub>2</sub> coatings on the surface of carbon fibers.</p>","PeriodicalId":757,"journal":{"name":"Russian Journal of Applied Chemistry","volume":null,"pages":null},"PeriodicalIF":0.6000,"publicationDate":"2024-03-12","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":"{\"title\":\"Effect of Surface Modification of Carbon Fibers on the Formation of SiO2 Coatings\",\"authors\":\"R. F. Gallyamova,&nbsp;S. A. Grabovskiy,&nbsp;V. A. Dokichev,&nbsp;F. F Musin\",\"doi\":\"10.1134/S1070427223050142\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"<p>Surface modification of carbon fiber with 1,1-dihydroperoxycyclohexane (DHPC) before application of SiO<sub>2</sub> barrier coating was studied. IR spectroscopy showed presence of the COOH carboxyl groups on the surface of modified carbon fibers. The modified surface has less hydrophobicity due to the presence of polar groups, which contribute to a change in the wettability of the fiber by the sol–gel solution and the adhesion of the oxide coating to the fiber surface. The quality and thickness of the oxide coatings were assessed by scanning electron microscopy. The use of DHPC leads to oxidation of the carbon fiber, making surface longitudinal stripes deeper. To determine the effect of DHPC modification on the properties of the fiber surface, a SiO<sub>2</sub> coating was applied by immersion in a tetraethoxysilane sol. DHPC modification leads to the formation of a uniform SiO<sub>2</sub> coating on the fiber surface. After the heat treatment, the coating thickness on the DHPC–modified fibers is 130 ± 30 nm. Analysis of the IR spectra showed that the addition of DHPC to the sol leads to an increase in the intensity of the Si–O–Si, Si–OH, and OH absorption bands, which are characteristic of the hydrolysis and polycondensation products of tetraethoxysilane. In the wavenumber range of 400–1200 cm<sup>–1</sup>, the Si–O–Si fragments form, which is confirmed by the presence of bands of Si–O– deformation bond at ν = 881 and 442 cm<sup>–1</sup>. The introduction of DHPC into the sol promotes the formation of a uniform coating on the carbon fibers. The coating thickness on the initial fibers reaches 410±100 nm at room temperature, decreasing to 190±60 nm after heating. The fiber and sol modification contribute to formation of a uniform coating with a thickness of 200 ± 70 nm and 130 ± 30 nm before and after the heating, respectively. DHPC modification of the fiber surface and tetraethoxysilane sol promotes the formation of continuous, uniform, and quality SiO<sub>2</sub> coatings on the surface of carbon fibers.</p>\",\"PeriodicalId\":757,\"journal\":{\"name\":\"Russian Journal of Applied Chemistry\",\"volume\":null,\"pages\":null},\"PeriodicalIF\":0.6000,\"publicationDate\":\"2024-03-12\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"Russian Journal of Applied Chemistry\",\"FirstCategoryId\":\"92\",\"ListUrlMain\":\"https://link.springer.com/article/10.1134/S1070427223050142\",\"RegionNum\":4,\"RegionCategory\":\"化学\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q4\",\"JCRName\":\"CHEMISTRY, APPLIED\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"Russian Journal of Applied Chemistry","FirstCategoryId":"92","ListUrlMain":"https://link.springer.com/article/10.1134/S1070427223050142","RegionNum":4,"RegionCategory":"化学","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q4","JCRName":"CHEMISTRY, APPLIED","Score":null,"Total":0}
引用次数: 0

摘要

摘要 研究了在涂覆二氧化硅阻挡层之前用 1,1-二氢过氧环己烷 (DHPC) 对碳纤维进行表面改性的情况。红外光谱显示改性碳纤维表面存在 COOH 羧基。由于极性基团的存在,改性后的碳纤维表面疏水性较低,这有助于改变溶胶-凝胶溶液对纤维的润湿性以及氧化物涂层对纤维表面的附着力。氧化物涂层的质量和厚度由扫描电子显微镜进行评估。使用 DHPC 会导致碳纤维氧化,使表面纵向条纹加深。为了确定 DHPC 改性对纤维表面特性的影响,将 SiO2 涂层浸入四乙氧基硅烷溶液中。DHPC 改性可在纤维表面形成均匀的二氧化硅涂层。热处理后,DHPC 改性纤维的涂层厚度为 130 ± 30 nm。对红外光谱的分析表明,溶胶中加入 DHPC 后,Si-O-Si、Si-OH 和 OH 吸收带的强度增加,这些吸收带是四乙氧基硅烷水解和缩聚产物的特征。在 400-1200 cm-1 波长范围内,Si-O-Si 片段形成,ν = 881 和 442 cm-1 处出现的 Si-O- 变形键带证实了这一点。在溶胶中加入 DHPC 可促进在碳纤维上形成均匀的涂层。初始纤维的涂层厚度在室温下达到 410±100 nm,加热后降至 190±60 nm。在加热前后,纤维和溶胶改性有助于形成厚度分别为 200±70 nm 和 130±30 nm 的均匀涂层。纤维表面的 DHPC 改性和四乙氧基硅烷溶胶促进了碳纤维表面连续、均匀和高质量 SiO2 涂层的形成。
本文章由计算机程序翻译,如有差异,请以英文原文为准。

Effect of Surface Modification of Carbon Fibers on the Formation of SiO2 Coatings

Effect of Surface Modification of Carbon Fibers on the Formation of SiO2 Coatings

Effect of Surface Modification of Carbon Fibers on the Formation of SiO2 Coatings

Surface modification of carbon fiber with 1,1-dihydroperoxycyclohexane (DHPC) before application of SiO2 barrier coating was studied. IR spectroscopy showed presence of the COOH carboxyl groups on the surface of modified carbon fibers. The modified surface has less hydrophobicity due to the presence of polar groups, which contribute to a change in the wettability of the fiber by the sol–gel solution and the adhesion of the oxide coating to the fiber surface. The quality and thickness of the oxide coatings were assessed by scanning electron microscopy. The use of DHPC leads to oxidation of the carbon fiber, making surface longitudinal stripes deeper. To determine the effect of DHPC modification on the properties of the fiber surface, a SiO2 coating was applied by immersion in a tetraethoxysilane sol. DHPC modification leads to the formation of a uniform SiO2 coating on the fiber surface. After the heat treatment, the coating thickness on the DHPC–modified fibers is 130 ± 30 nm. Analysis of the IR spectra showed that the addition of DHPC to the sol leads to an increase in the intensity of the Si–O–Si, Si–OH, and OH absorption bands, which are characteristic of the hydrolysis and polycondensation products of tetraethoxysilane. In the wavenumber range of 400–1200 cm–1, the Si–O–Si fragments form, which is confirmed by the presence of bands of Si–O– deformation bond at ν = 881 and 442 cm–1. The introduction of DHPC into the sol promotes the formation of a uniform coating on the carbon fibers. The coating thickness on the initial fibers reaches 410±100 nm at room temperature, decreasing to 190±60 nm after heating. The fiber and sol modification contribute to formation of a uniform coating with a thickness of 200 ± 70 nm and 130 ± 30 nm before and after the heating, respectively. DHPC modification of the fiber surface and tetraethoxysilane sol promotes the formation of continuous, uniform, and quality SiO2 coatings on the surface of carbon fibers.

求助全文
通过发布文献求助,成功后即可免费获取论文全文。 去求助
来源期刊
CiteScore
1.60
自引率
11.10%
发文量
63
审稿时长
2-4 weeks
期刊介绍: Russian Journal of Applied Chemistry (Zhurnal prikladnoi khimii) was founded in 1928. It covers all application problems of modern chemistry, including the structure of inorganic and organic compounds, kinetics and mechanisms of chemical reactions, problems of chemical processes and apparatus, borderline problems of chemistry, and applied research.
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术官方微信