Ic measurement of twisted multifilamentary MgB2 wires with non-magnetic sheath over a wide range of temperatures and fields

All-superconducting rotating machines have the potential for meeting the high power density and high efficiency required for electrical aircraft applications. However, very high AC loss encountered in superconducting armature windings could hinder their development. Multifilamentary MgB₂ wires are one of the promising candidates for the stator windings, due to their potentially low AC loss properties with small filament size and twist pitches. As the first step, the dependence of critical current and n-value on magnetic fields and temperatures I_c(B, T) and n(B,T), which are basic input parameters for AC loss simulation, needs to be measured. In this work, we present transport I_c measurements in three non-magnetic multifilamentary MgB₂ wires (MgB₂/Nb/CuNi/CuZn): one large wire with a 0.70 mm diameter and 25 mm twist pitch, and two small wires with a 0.48 mm diameter each and a 10 mm and 30 mm twist pitch respectively. A four-probe direct current method is used to measure I_c of the MgB₂ wires with variations in temperature (15 – 35 K) and magnetic field (0 – 5.5 T). Full I_c data for the small wire with 10 mm twist pitch was obtained, and the n-values were mostly less than 20. While the I_c data for the large wire at low fields was more limited due to heating, the n-values were higher and could be up to around 100. The difference is attributed to the different filament sizes. Experiments also found that there is no significant hysteresis in the transport critical current measured by decreasing or increasing magnetic fields due to the non-magnetic sheaths. This non-hysteretic characteristic is critical for lowering AC loss because the additional losses from magnetic sheaths can be eliminated. From the magnetic-field dependence of critical current density, an empirical expression has been developed that provides suitable extrapolations to lower fields for the large wire.