Barbell Technique for Three-Dimensional Bone Augmentation

Introduction. Appositional bone augmentation is considered a challenging surgical problem to correct for the deficient alveolar ridge. To overcome this challenge, a novel concept was recently published called “Barbell Technique.” This technique has been used more commonly for horizontal bone augmentation. To our knowledge, this is the first report on using the Barbell Technique for vertical bone augmentation. Case Report. This report describes and demonstrates the clinical feasibility of the use of this concept in the reconstruction of a tridimensional alveolar ridge defect in the anterior maxilla. Due to the severity of the defect, both hard and soft tissue deficiencies required augmentation. The first surgery involved a soft tissue grafting procedure while in the second surgical procedure, hard tissue augment was performed using the Barbell device to provide both vertical and horizontal support for the hard tissue graft. The donor material consisted of equal volume of xenograft and autogenous bone used to fill the defect and covered with a collagen barrier membrane. After a healing period of 9 months, the site was reopened. Bone formation clinically verified the correction of alveolar bone contour and volume permitted placement of two titanium implants after the removal of Barbell device. Conclusion. This case report demonstrates successful vertical and horizontal bone augmentation of a critical size defect in the anterior maxilla, correcting both hard and soft tissue contours, and providing the tissues needed to support dental implants in the anterior maxilla.