Structure and Properties of the Bulk Standard Samples and Cellular Energy Absorbers

The development of additive technology revealed a real prospect of their use for the manufacture of complex shapes. Now, it is possible to produce parts that previously were either very difficult to produce using the subtracting technology and joining technology, or it was not at all feasible. In the manufacture of parts of complex shape, it is necessary to use a supporting structure, which is necessary to place such a way that they can be easily removed. Additionally, they must necessarily be absent in certain places. In this regard, the preparation model can take significant time to satisfy all of these, often conflicting, requirements. In this paper, we show optimization examples of the model preparation with support structures for parts manufactured at the facility EOSINT M270 and used in medicine and engineering. Additional emphasis is on the fact that, during the manufacture of parts, solidification’s modes of massive parts differ from those of the thin-walled portions of parts. The results of the complex studies on the different stainless steels (including martensitic) are described with an emphasis on their structure and mechanical properties. The results of a honeycomb energy absorbers, which are quite seldom produced by the additive technologies, are presented in this chapter.