Feed Cutting Force Component in Up and Down Sawing of Pine

IF 0.7 4区农林科学 Q4 MATERIALS SCIENCE, PAPER & WOOD

Drvna Industrija Pub Date : 2022-07-15 DOI:10.5552/drvind.2022.0018

L. Javorek, R. Kminiak, M. Vargovská, E. Csanády, S. Németh

引用次数: 1

Abstract

The monitoring of cutting force components is one of the possibilities to control machining processes from the point of view of its stability, machine tool spindle or cutting tool loading. This paper presents and compares the results of experimental longitudinal sawing of pine wood with 4 saw discs with different teeth number (16 and 24) and rake angle (10° and 20°) during up (conventional) and down (climb) cutting with different revolutions (4000 min-1, 5000 min-1, 6000 min-1) and feed speed (15 m/min, 20 m/min, 25 m/min). The signal was obtained from Quart 3-components piezoelectric dynamometer.

查看原文本刊更多论文

松材上下锯切时进给切削力的组成

从加工过程的稳定性、机床主轴或刀具载荷的角度来看，对切削力分量的监测是控制加工过程的一种可能性。本文介绍并比较了在不同转数(4000 min-1、5000 min-1、6000 min-1)和进给速度(15 m/min、20 m/min、25 m/min)下，用4个不同齿数(16和24)和前倾角(10°和20°)的锯片对松木进行上(常规)和下(爬坡)锯切的实验结果。信号由夸脱三分量压电测功仪获得。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Drvna Industrija MATERIALS SCIENCE, PAPER & WOOD-

CiteScore

1.80

自引率

9.10%

发文量

审稿时长

>12 weeks

期刊介绍： "Drvna industrija" ("Wood Industry") journal publishes original scientific and review papers, short notes, professional papers, conference papers, reports, professional information, bibliographical and survey articles and general notes relating to the forestry exploitation, biology, chemistry, physics and technology of wood, pulp and paper and wood components, including production, management and marketing aspects in the woodworking industry.