Epoxy Bonding of 3D-Printed Acrylonitrile–Styrene–Acrylate: Optimization of Shear Strength

IF 0.58 Q4 Materials Science

Polymer Science, Series D Pub Date : 2026-09-04 DOI:10.1134/S1995421226700759

A. P. Vasiliev, A. A. Okhlopkova

引用次数: 0

Abstract

This article proposes a method for preparing a surface for bonding 3D-printed acrylonitrile–styrene–acrylate (ASA) with epoxy resin. Effect of the fill rate (0, 30, 60, 90%) of the bonded part on the shear strength of adhesive joint is studied. It was found that samples with 60% fill rate exhibit maximum strength, with failure occurring at the base rather than the adhesive joint. Optimal surface preparation improves adhesion and bond strength. Method developed can be used in the production of large-scale parts using 3D-printed ASA.

查看原文本刊更多论文

3d打印丙烯腈-苯乙烯-丙烯酸酯环氧键合：剪切强度优化

本文提出了一种制备3d打印丙烯腈-苯乙烯-丙烯酸酯（ASA）与环氧树脂粘合表面的方法。研究了粘结件填充率（0、30、60、90%）对粘结接头抗剪强度的影响。结果表明，当充填率为60%时，试样的强度最大，破坏发生在底部而非粘接处。最佳表面处理提高附着力和结合强度。所开发的方法可用于使用3d打印ASA生产大型部件。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Polymer Science, Series D Materials Science-Polymers and Plastics

CiteScore

0.80

自引率

0.00%

发文量

期刊介绍： Polymer Science, Series D publishes useful description of engineering developments that are related to the preparation and application of glues, compounds, sealing materials, and binding agents, articles on the adhesion theory, prediction of the strength of adhesive joints, methods for the control of their properties, synthesis, and methods of structural modeling of glued joints and constructions, original articles with new scientific results, analytical reviews of the modern state in the field.