A Study of the Influence of Molding Technology on the Mechanical and Elastic Properties of Basalt Plastics Based on Epoxy Binder

IF 0.58 Q4 Materials Science

Polymer Science, Series D Pub Date : 2025-03-16 DOI:10.1134/S1995421224701491

A. S. Borodulin

引用次数: 0

Abstract

Results of studies of the strength and elasticity moduli of basalt plastics during their tests for tension, bending, compression, interlayer shear, and crack resistance depending on the technology of their manufacture are presented. Three molding technologies were used in the work: vacuum infusion, impregnation under pressure, and contact molding technology from prepreg. It was experimentally found that the highest values (of the studied mechanical characteristics) are achieved when manufacturing samples using RTM technology, and the lowest when using vacuum infusion.

查看原文本刊更多论文

成型工艺对环氧粘结剂玄武岩塑料力学和弹性性能影响的研究

介绍了不同生产工艺下玄武岩塑料的拉伸、弯曲、压缩、层间剪切和抗裂试验强度和弹性模量的研究结果。采用了真空灌注、加压浸渍和预浸料接触成型三种成型工艺。实验发现，采用RTM工艺制备样品时，所研究的力学特性值最高，采用真空灌注工艺制备样品时，所研究的力学特性值最低。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

求助全文

约1分钟内获得全文求助全文

来源期刊

Polymer Science, Series D Materials Science-Polymers and Plastics

CiteScore

0.80

自引率

0.00%

发文量

期刊介绍： Polymer Science, Series D publishes useful description of engineering developments that are related to the preparation and application of glues, compounds, sealing materials, and binding agents, articles on the adhesion theory, prediction of the strength of adhesive joints, methods for the control of their properties, synthesis, and methods of structural modeling of glued joints and constructions, original articles with new scientific results, analytical reviews of the modern state in the field.