Surface Quality and Compressive Properties of Mortise and Tenon Lattice Structures Fabricated by Fused Deposition Modeling.

Abstract

To address the anisotropy of mechanical properties and the challenge of removing support materials in lattice structures fabricated using fused deposition modeling (FDM), this study is inspired by traditional woodworking mortise and tenon joints. A hexagonal interlocking mortise lattice structure was designed, and mortise and tenon lattice structures (MTLSs) with various parameters were fabricated. Compared with the traditional integrated forming lattice structure (IFLS), the MTLS exhibits maximum reductions in side surface roughness (Ra), printing time, and material consumption of 74.87%, 25.55%, and 52.21%, respectively. In addition to enhancing surface quality and printing efficiency, the MTLS also exhibited superior mechanical properties. The uniaxial compression test results show that the specific strength, energy absorption (EA), and specific energy absorption (SEA) of the MTLS exhibit maximum increases of 51.22%, 894.59%, and 888.39%, respectively, compared with the IFLS. Moreover, the effects of strut angle and thickness on the lattice structure were analyzed. Smaller strut angles and larger strut thicknesses endowed greater strength, while smaller angles contributed to higher energy absorption. This study proposes a novel approach for designing lattice structures in additive manufacturing.