Physics-based time-of-failure determination of rainfall-induced instability in lateritic soil slopes

IF 6.9 1区 工程技术 Q1 ENGINEERING, GEOLOGICAL
Sushant Rahul, Akanksha Tyagi
{"title":"Physics-based time-of-failure determination of rainfall-induced instability in lateritic soil slopes","authors":"Sushant Rahul, Akanksha Tyagi","doi":"10.1016/j.enggeo.2024.107834","DOIUrl":null,"url":null,"abstract":"Conventional time-of-failure estimated from slope surface displacement over time, ignores the crucial geotechnical and environmental causative factors that lead to slope instability. The instrumentation and monitoring are expensive, labour-intensive, and often not feasible for large number of hill slopes. This paper focuses on the physics-based determination of time-of-failure charts for laterite soil slopes prevalent in the Western Ghats of India, under rainfall infiltration. The finite element model was first validated by performing coupled flow deformation analysis of Kondavi soil cutting situated in the Ratnagiri district of Maharashtra, India. The soil samples were collected from the site for basic geotechnical characterisation in the laboratory. In addition, the soil water characteristics curve (SWCC) was determined using the filter paper method, and the unsaturated parameters were obtained using the van Genuchten model. Following the validation of numerical model with the failed Kondavi cutting, the factor of safety (FOS) and time-of-failure (TOF) were studied for varying rainfall intensity, and permeability of the soil. The FOS and TOF charts were then established for varying slope angles (30°, 45°, 60°), effective cohesion (10 kPa, 18 kPa, 25 kPa), effective friction angle (22°, 25°, 28°), water table depth (25 m, 28 m, 30 m, 35 m) and height of slope (15 m, 25 m, 35 m). Results indicate that if rainfall intensity is lower than soil permeability, TOF depends on both the intensity and duration of the rainfall. Higher rainfall intensity leads to a shorter time of failure, and vice versa. Conversely, when rainfall intensity exceeds soil permeability, TOF is determined by the duration of rainfall and the permeability of soil, as the rainfall infiltrates at the saturated permeability rate regardless of its intensity. It is also observed that friction is the dominant parameter for initial FOS, while cohesion is the dominant parameter for the TOF of a rainfall-induced landslide. Finally, charts are proposed that shall serve as a preliminary guide for the determination of the TOF for rainfall-induced instability in the lateritic soil slopes of India. The performance of the charts is further evaluated by comparing the observed and predicted TOF of two other failed laterite cuttings. The implications of these findings are profound, as the proposed TOF charts can be integrated into early warning systems, contributing towards improved disaster mitigation and preparedness with timely decision making for adequate management of landslide associated risks.","PeriodicalId":11567,"journal":{"name":"Engineering Geology","volume":"244 1","pages":""},"PeriodicalIF":6.9000,"publicationDate":"2024-12-02","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"Engineering Geology","FirstCategoryId":"89","ListUrlMain":"https://doi.org/10.1016/j.enggeo.2024.107834","RegionNum":1,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q1","JCRName":"ENGINEERING, GEOLOGICAL","Score":null,"Total":0}
引用次数: 0

Abstract

Conventional time-of-failure estimated from slope surface displacement over time, ignores the crucial geotechnical and environmental causative factors that lead to slope instability. The instrumentation and monitoring are expensive, labour-intensive, and often not feasible for large number of hill slopes. This paper focuses on the physics-based determination of time-of-failure charts for laterite soil slopes prevalent in the Western Ghats of India, under rainfall infiltration. The finite element model was first validated by performing coupled flow deformation analysis of Kondavi soil cutting situated in the Ratnagiri district of Maharashtra, India. The soil samples were collected from the site for basic geotechnical characterisation in the laboratory. In addition, the soil water characteristics curve (SWCC) was determined using the filter paper method, and the unsaturated parameters were obtained using the van Genuchten model. Following the validation of numerical model with the failed Kondavi cutting, the factor of safety (FOS) and time-of-failure (TOF) were studied for varying rainfall intensity, and permeability of the soil. The FOS and TOF charts were then established for varying slope angles (30°, 45°, 60°), effective cohesion (10 kPa, 18 kPa, 25 kPa), effective friction angle (22°, 25°, 28°), water table depth (25 m, 28 m, 30 m, 35 m) and height of slope (15 m, 25 m, 35 m). Results indicate that if rainfall intensity is lower than soil permeability, TOF depends on both the intensity and duration of the rainfall. Higher rainfall intensity leads to a shorter time of failure, and vice versa. Conversely, when rainfall intensity exceeds soil permeability, TOF is determined by the duration of rainfall and the permeability of soil, as the rainfall infiltrates at the saturated permeability rate regardless of its intensity. It is also observed that friction is the dominant parameter for initial FOS, while cohesion is the dominant parameter for the TOF of a rainfall-induced landslide. Finally, charts are proposed that shall serve as a preliminary guide for the determination of the TOF for rainfall-induced instability in the lateritic soil slopes of India. The performance of the charts is further evaluated by comparing the observed and predicted TOF of two other failed laterite cuttings. The implications of these findings are profound, as the proposed TOF charts can be integrated into early warning systems, contributing towards improved disaster mitigation and preparedness with timely decision making for adequate management of landslide associated risks.
求助全文
约1分钟内获得全文 求助全文
来源期刊
Engineering Geology
Engineering Geology 地学-地球科学综合
CiteScore
13.70
自引率
12.20%
发文量
327
审稿时长
5.6 months
期刊介绍: Engineering Geology, an international interdisciplinary journal, serves as a bridge between earth sciences and engineering, focusing on geological and geotechnical engineering. It welcomes studies with relevance to engineering, environmental concerns, and safety, catering to engineering geologists with backgrounds in geology or civil/mining engineering. Topics include applied geomorphology, structural geology, geophysics, geochemistry, environmental geology, hydrogeology, land use planning, natural hazards, remote sensing, soil and rock mechanics, and applied geotechnical engineering. The journal provides a platform for research at the intersection of geology and engineering disciplines.
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术官方微信