Conceptual modelling on water-rock reaction and genesis of high pH fluids in a typical granitoid geothermal reservoir: A case from Indus-Tsangpo Suture Zone, India

Abstract

Two novel thermal springs are investigated along ITSZ of north-west Himalayas in Demchok geothermal belt. The area consists of deep-seated faults in LGB; despite being situated in ITSZ, fluid chemistry of these low-temperature springs differs significantly, specifically in terms of low TDS (161–168 mg/l) and high alkalinity, with neighbouring springs in Puga and Chumathang (∼2100 mg/l). Thermal waters are mixed type (Na–Cl–HCO₃–SO₄) with elemental composition influenced through silicate rock weathering and partial carbonate dissolution. Variable temperature speciation (25 °C–200 °C) indicates that in reservoir fluid, Na⁺ precedes over other cations, while sulfate and carbonate complexes being prominent for Mg and Ca, respectively. Aquifer boiling modelling suggests calcite scaling and silica mineral equilibration in reservoir. Environmental stable isotopes (δ¹⁸O and δD) suggest high-altitude recharge from Jamlung La (6156 m), with altitude-effect of 0.43 ‰ isotopic depletion per 100 m elevation in altitude. As only silica minerals equilibrate with thermal waters, silica, and gas geothermometers give most conservative estimate of reservoir temperature (125°−135 °C). The steep topography enables extensive lateral flow of hot fluids in outflow zone, leading to high mixing and a high water-rock ratio, which contribute to lower TDS. Conceptual modelling reveals that geothermal system is a low-enthalpic hydrothermal system controlled by joints and permeable fractures, having deep fluid circulation of meteoric waters of ∼1275 m at sub-surface, with anomalous geothermal gradient and steam migration as reservoir heat sources. These fluids closely resemble springs of Guerrero state, Mexico, exhibiting similarities in low-TDS, high-pH, and high concentration of dissolved silica.