Performance of an additive-manufactured precooler under high-temperature and negative pressure environment

Abstract

This paper introduces an original plate-fin precooler designed for potential applications in extreme low-pressure environments. Utilizing additive manufacturing technology, the heat transfer plate thickness is constrained to 2.0 mm, with channel widths inside the plate achieving 0.8 mm. Through experimental methods, this study aims to assess the precooler’s performance and identify critical influencing factors. Experimental results indicate that the hot fluid inlet temperature to the precooler exceeds 1100 K, with static pressures dropping below 30 kPa. Despite these conditions, the precooler demonstrates an impressive pressure recovery coefficient exceeding 97 % and achieves a maximum temperature drop of 731.4 K for the hot fluid. Furthermore, it is observed that the overall performance of the precooler diminishes with increasing mass flow rates of the hot fluid, showing fluctuations of up to 25 % when assessed by the j/f^1/3 factor. Additionally, while the hot fluid inlet velocity exceeds 90 m/s, laminar flow predominates during the heat transfer process. Moreover, regardless of whether the cooling fluid experiences a phase change within the precooler, its heat transfer performance show priority than that of the hot fluid. Thus, changes in the mass flow rate of the cooling fluid have minimal impact on the overall precooler performance. Finally, the first-stage heat exchanger plays a critical role in the heat transfer process, accounting for over 2/3 of the total temperature and pressure drop for the hot fluid. This research is expected to contribute to the design of high-efficiency, low-resistance precoolers, particularly those applied for operation under negative pressure conditions.