Predicting the mechanical properties of timber from existing structures by the longitudinal vibration method, visual grading and definition of the nominal cross-section

Abstract

ABSTRACTThe modulus of elasticity (MOE), bending strength (MOR) and density of 45 150 × 200 × 5400 mm3 Salzmann pine timber pieces from an existing eighteenth century structure were obtained by testing and also estimated by non-destructive testing. Density was estimated by means of the drilling technique and the MOE and MOR by recording the longitudinal natural frequency of vibration. Four methods for defining the dimensions of the nominal cross-section were applied to establish which was most adequate to address the high variability in the cross-sections along the length. MOE and MOR linear regression results showed r2 = 59–68% using dynamic MOE, relative edge knot diameter and slope of grain as independent variables. The nominal cross-section defined as the mean cross-section area along the length proved to be the most effective for estimating mechanical properties, followed by the nominal cross-section defined as the average measurements of the piece taken at the middle part or central third along its length. The longitudinal vibration method enables the acquisition of superior predictive models compared to time-of-flight measurement-based methods.KEYWORDS: Bending strengthin-situ assessmentmodulus of elasticitydrillingresonancetimber AcknowledgmentsMinisterio de Economía y Competitividad [Spanish Ministry of Economy and Competitiveness]. Plan Nacional I+D 2013–2016. Proj.: BIA 2014-55089-P. We would like to thank Mr. Antonio Arce from Intrama S.A. for the free supply of timber. Partial financial support (OTT D200, English revision) by Universidad Politécnica de Madrid, Spain. The technical support offered by Ramón García Lombardero for measurements was greatly appreciated.Disclosure statementNo potential conflict of interest was reported by the author(s).