Konvansiyonel, CAD/CAM frezeleme ve 3D baskı yöntemleriyle üretilmiş geçici materyallerin yüzey özelliklerinin Streptococcus mutans ve Candida albicans tutunumuna etkileri

Abstract

Objectives: The purpose of this in vitro study was to compare conventionally manufactured, CAD/CAM milled, and 3D-printed interim materials based on their susceptibility to adherence of Streptococcus mutans and Candida albicans, and examine the influence of surface roughness and hydrophobicity. Materials and Methods: Eighty disc-shaped specimens fabricated from autopolymerized polymethyl methacrylate (A-PMMA), bis-acryl composite (Bis-acrylate), CAD/CAM PMMA-based polymer (Milled-PMMA), and 3D-printed resin (Printed) were subjected to 10,000 thermal cycles (5-55 °C) and divided into two groups (n=10) according to microbial suspension used: Streptococcus mutans and Candida albicans. Surface roughness (Ra) and hydrophobicity (WCA) of specimens were measured. An adhesion test was performed by incubating the specimens in Streptococcus mutans and Candida albicans suspensions at 37 °C for 24 hours, and the adherent cells were evaluated by counting colony-forming units (CFU/ml). Scanning electron microscopy (SEM) was performed to analyze the surfaces (n=2). Data were analyzed with Kruskal-Wallis and Mann-Whitney U tests. Spearman’s correlation analysis was used to determine correlation among the measurements (α=.05). Results: Type of restorative material significantly influenced Ra and WCA. The highest adhesion of Streptococcus mutans was observed in Printed, followed by Bis-acrylate, A-PMMA, and Milled-PMMA (p=.001). The highest adhesion of Candida albicans was noted on A-PMMA, followed by Printed, Bis-acrylate, and Milled-PMMA (r=.001). The adhesion of Streptococcus mutans (r=.660) and Candida albicans (r=.413) showed a positive correlation with Ra. A negative correlation was found between WCA of the materials and Streptococcus mutans adhesion (r=-.373). Conclusions: Surface roughness plays an important role in the adherence of microorganisms. CAD/CAM PMMA-based polymers may be a better choice to reduce microbial adhesion in long-term use.