Inertial Sensor-Based State Estimation of Flexible Links Subject to Bending and Torsion

Abstract

In this study, we propose an observer design based on inertial sensors and the finite element (FE) method to estimate the flexural states of a long-reach and highly flexible manipulator in a 3D plane of motion. Vertical and lateral dynamic bendings are considered, along with deformation due to torsion. The aim is to achieve accurate end-point positioning by using the estimated flexural degrees-of-freedom, which are formulated using an FE model. The states are reconstructed based on angular velocity measurements, which are obtained from strap-on inertial sensors placed along the flexible link. For validation, a motion-capture setup consisting of three OptiTrack cameras is used. The experiments are conducted on a hydraulic manipulator that has a single 4.5-m long flexible link with a tip mass. The validation is carried out by comparing the estimates to the OptiTrack reference measurements. The results demonstrate that this method provides satisfactory end-point positioning, while also being convenient for use in heavy-duty mobile manipulators.