Low AOB Component Loads Derivation to Implement MH-60R HUMS

Abstract

Presently the fatigue lives of MH-60R dynamic components and airframe are based on a usage spectrum developed using pilot surveys. In order to better define the usage spectrum and to extend component and airframe fatigue life, the Health & Usage Spectrum (HUMS) System was installed on the U.S. Navy MH- 60R Rotorcraft. So far 207 aircraft are equipped with the HUMS systems and 121,334 flight hours of good data have been recorded. The regime recognition programs recognize 315 maneuvers, but are consolidated to 94 maneuvers of MH-60R usage spectrum, for which the component measured loads are available. To better define usage spectrum in detail and compute realistic component fatigue life, an additional maneuver of low Angle Of Bank (AOB) from 10 to 25 degrees was added, but the measured component loads were not available at this AOB to implement HUMS. Thus, measured flight loads data of level flight and AOB turns at 30, 45, and 60 degrees were utilized to derive component loads at 20 degrees by spline cubic interpolation technique. The cubic interpolation technique was applied to measured minimum, average, and maximum loads of variation at 10, 30, 45, and 60 degrees to interpolate load at 20 degree. This technique was applied to interpolate loads for pitch control rod, swash-plate, drag damper, shaft bending moments, blade cuff stresses, and flap deflections. The spline interpolation loads correlated with measured available loads of pitch control rod and blade stresses. The probabilistic fleet usage spectrum of various severities was developed using the HUMS recorded data of 121, 334 hours from 179 rotorcraft with and without low AOB usage. It is evident that fatigue life with 20 AOB split is significantly higher for all dynamic components. Thus, to implement HUMS successfully, it is necessary to compute loads that are not available in the original component fatigue life calculations. Further prorates of gross weigh (GW), velocity and altitude based on the HUMS fleet usage should be implemented to extend component fatigue lives.