外部加压轴承。制造用设计。第1部分。轴颈轴承的选择

Q3 Engineering

Mocaxue Xuebao/Tribology Pub Date : 1974-06-01 DOI:10.1016/0041-2678(74)90009-8

K.J. Stout (Project Consultant, Senior Lecturer) , W.B. Rowe (Head of Mechanical, Marine and Production Engineering)

引用次数: 48

摘要

有关的信息选择配置几何，控制装置和材料的气体和液体进料轴承包括在内。给出了关于实现系统总可靠性的附加指导。

本文章由计算机程序翻译，如有差异，请以英文原文为准。

查看原文本刊更多论文

Externally pressurized bearings — design for manufacture Part 1 — journal bearing selection

Information relating to the selection of configuration geometry, control devices and materials for both gas and liquid feed bearings is included. Additional guidance is given concerning the achievement of total system reliability.

求助全文

通过发布文献求助，成功后即可免费获取论文全文。去求助

来源期刊

Mocaxue Xuebao/Tribology Engineering-Mechanical Engineering

CiteScore

1.90

自引率

0.00%

发文量

3489

期刊介绍： As the most authoritative comprehensive science periodical covering all branches of Tribology in China, “Tribology” deals with various academic, technological, and engineering topics in the interdisciplinary subjects of Mechanical Science and Technology, Materials Science and Engineering, Physics, Chemistry, Mechanics, etc. It covers new achievements in the fundamental, applied fundamental, and applied researches in Tribology, reflects the development and direction of Tribology at home and abroad, helps to find and train young scholars, speeds up extensive academic exchange, promotes the development of Tribology subject, and serves for the development of economy and society.