Successful Implementation of Polymer Flood in Aishwariya Field, Rajasthan, India - Concept to Full Field

The Aishwariya Oil Field located in Barmer Basin of Rajasthan India having STOIIP of ∼300 MMBBLS was initially developed with down-dip edge water injection. The main reservoir unit, Fatehgarh Formation, has excellent reservoir characteristics with porosities of 20-30% and permeability of 1 to 5 Darcys. The Fatehgarh Formation is subdivided into Lower Fatehgarh (LF) and Upper Fatehgarh (UF) Formations, of which LF sands are more homogenous and have slightly better reservoir properties. The oil has in-situ viscosity of 10-30 cP. Given its adverse waterflood mobility ratio, the importance of EOR was recognised very early. Initial screening studies identified that chemical EOR (polymer and ASP) was preferred choice of EOR process. Extensive lab studies and simulation work was conducted to develop the polymer flood concept. A polymer flood development plan was prepared targeting the LF sands of the field utilizing the lessons learnt from nearby Mangala Field polymer implementation project. The polymer flood in Aishwariya Field was implemented in two stages. In the first stage, a polymer injectivity test was conducted in 3 wells to establish the potential for polymer injection in these wells. The injection was extended to 3 more wells and continued for ∼4 years. Significant water cut drop was observed in nearby wells during this phase of polymer injection. In the next stage, polymer flooding was extended to the entire LF sands with drilling of 14 new infill wells and conversion of 8 existing wells to polymer injectors. A ∼14 km long pipeline was laid from the Mangala Central Polymer Facility to well pads in the field to cater to the requirement of 6-8 KBPD of ∼15000 ppm polymer mother solution. The philosophy of pre-production for extended periods was considered prior to start of polymer injection for all wells as it significantly improved injection (reduced skin) and conformance. Full field polymer flood project was implemented, and injection was ramped up to the planned 40-50 KBPD of polymerized water within a month owing to good injectivity and polymer solution quality. A detailed laboratory, well and reservoir surveillance program has been implemented and the desired wellhead viscosity of 25-30 cP has been achieved. Initial response shows significant increase in oil production rate and decrease in water-cut. This paper presents the polymer laboratory studies, initial long term injectivity test results, polymer flood development concept and planning, simulation studies and field implementation in LF Formation in Aishwariya Field.