Swinging Water Injection Targets SWIT

With increasing wells connected to central facilities, it is hard to manage water flood using traditional technique. Therefore, a novel control concept named Swinging Water Injection Targets (SWIT) was developed in PDO to manage the challenges and satisfies both surface/subsurface requirements. The objectives of SWIT are: Maximize water injection well compliance. Minimize oil deferment due to water disposal restriction. Automated system that manages the variations in produced water flow with minimum interventions. SWIT concept is using the tolerance of ± 20% of desired injection target (Compliance limit) for each water injection (WI) well. So rather than having a fixed target, a minimum and maximum injection flow are giving to each WI well flow controller. Those range are provided by subsurface to ensure minimal impact for the rate fluctuation. The injection flows are driven by WI header pressure controller. When the produced water, the WI header pressure increases then the pressure controller to control the pressure asks all WI wells simultaneously increasing their injection flow at the same relative portion (Optimized distribution). Also, when the produced water decreases all WI flow starts reducing in the same way. SWIT concept proved success in PDO and it became a standard. It was first introduced in small field. Later, it was replicated across the company fields. The biggest scale implementation was in a cluster with more than 500 WI wells. Previously, in that cluster the WI header pressure was fluctuating indicating issues with water balance. Many manual adjustments were required to manage the situations when the produced water is more than the injection demand by closing oil producers leading to a considerable deferment due to water disposal restriction. Also, when the supply water is less than injection demand many WI wells start under injecting leading to low injection compliance. After SWIT was introduced in the cluster and all injectors started swinging in harmony via automatic control, it managed to balance the water system (controlled WI header pressure) regardless of the variation in produced water production. This resulted in increase of WI compliance by 5% after implementation. As SWIT optimized the water distribution to the injectors, roughly around 50 m3/d of additional oil production was achieved. It also minimized deferment from disposal restriction to a minimum level. All of this without the hustle of manual interventions.