Comparison of Process Parameters on Mild Steel and SS304 Through Statistical Analysis of Optimization Technique

The present study concentrated on the variation of process parameters on metal removal rate (MRR) used in turning of widely used material (stainless steel 304 and Mild steel). Turning is essential and robust process of material removal in the form of chips. The Turning process involved lots of process parameters as tool geometry, feed rate, rotational speed of job and rigidity of machine tools etc. In the present work study was done on the following cutting parameters as cutting speed (85,150 and 250 rpm), feed rate (0.13, 0.28 and 0.15, 0.09 mm/sec), depth of cut (0.4, 0.7 and 1 mm). The three label orthogonal array for process parameters were selected for metal removal rate analysis. The carbide tipped cutting tool was selected as cutting tool of positive rake angle. The analysis of process parameters was done through Minitab 17 software. The orthogonal array was selected 3*3; by the use of signal to noise (S/N) ratio is to minimise the variation due to uncontrolled parameters with the help of Taguchi method. Total nine experiments were performing on stainless steel and other set of nine experiments were perform on the mild steel. The experimental results reveals that moderate cutting speed 150 rpm, 0.09 mm/sec feed rate and 1 mm depth of cut yield good results for stainless steel 304 grade and mild steel.