Simultaneous Estimation of Genotoxic Impurities 4-Nitrobenzene Trifluoride, 4-Aminobenzene Trifluoride, and Benzo Trichloride in Cinacalcet Hydrochloride by GC-MS/MS Method

The main objective of this study is to develop and validate a novel, fast, and more sensitive gas chromatography-mass spectrometry (GC-MS/MS) method for the simultaneous estimation of 4-Nitrobenzotrifluoride (4-NBTF), 4-Amino-benzotrifluoride (4-ABTF), and Benzotrichloride (BTC) impurities in Cinacalcet hydrochloride (CH). The chromate-graphic separations were performed on a DB-624, 30m × 0.32mm × 1.8µm column with injector temperature of 150°C, and mode of injection is split with asplit ratio 1: 20. The carrier gas used was helium with a flowrate 1.5 mL/min, and theinjection load was 1.0 µL. Mass spectrometry quantitation was achieved by aquadrupole analyser with EI (Electron Ionization) ion source atasource temperature of 250ºC and interface temperature of 250ºC. The retention times for 4-NBTF, 4-ABTF, and BTC were at 6.13, 6.74and 7.64min, respectively. The calibration curve was linear over the concentration ranging from LOQ level to 150 % level with the correlation coefficient (r) of > 0.99. The percentage recovery was found to be within the specified range, i.e., 70.0 to 130.0 for the three impurities. The limit of detection (LOD) was established to 0.19, 0.19, and 0.18 ppm, whereas thelimit of quantification (LOQ) was obtained to 1.14, 1.12, and 1.11 ppm for 4-NBTF, 4-ABTF, and BTC, respectively. The test solutions with impurities were found to be stable in the diluent for 24 hours. A simple GC-MS/MS method was developed and validated for simultaneous estimation of three impurities in CH. The method was accurate, precise, linear, specific, sensitive, robust, and rugged as per ICH guidelines. The method has been applied to the real-time batch analysis and found to be suitable for routine quality control analysis of CH.