Breaking ERD Records with Optimized Engineering and Practices: Making the Impossible Possible

Long-extended reach drilling (ERD) well has become necessary to reach untapped resources. This paper will describe pre-planning, execution and post results of drilling ERD wells with large bore design of 12¼" as the main step out section and deploying 9⅝" casing on shallow TVD of 4,200’. Progressive increase of the ERD ratio and complexity from one well to the next was planned and executed till we reached the longest well deploying 8 KM of 9⅝" casing with 5.4 ERD ratio at 26,179' TD horizontally all the way. A learning curve was established on drilled wells while progressively increasing reach and complexity. Subject well was the longest of any well planned in the field by far. Success involved implementation of technically modeled engineered solutions and verified during execution. Operational procedures including but not limited to: proper planning and execution of well profile to ensure optimum placement in a specific formation and minimum side forces. Drilling and tripping procedures to ensure the lowest friction factor (FF) and allow drilling to target depth (TD) with optimum rig capability. Engineered solution for casing running technologies, which involved rotation and conventional running and floatation. The longest ERD well was drilled to 26,179' TD with field ROP record in 12¼" hole section, maintaining very good hole quality proved by smooth bit trips out of hole and the final trip at TD on elevators. Hole cleaning and fluids strategy was developed and executed efficiently to measure FFs as low as possible for successful 9⅝" deployment. Engineered solution was proposed for 9⅝" deployment and was successfully trial tested on a shorter well to validate simulations. Casing rotation FFs came close to the modeled FFs. The 9⅝" Casing was deployed to bottom as planned and the cement job was performed successfully. Various records were achieved: the subject well achieved the deepest 9⅝" horizontal casing, the deepest 12¼" horizontal at TVD shallower than 5,000'. The longest 12¼" horizontal open hole at TVD shallower than 5,000' with section footage of 16,164'. The 9⅝" casing was deployed as a long string, eliminating the cost and challenges of a liner hanger and the need for a future tieback and also keeping hole sizes available for main and contingency sections to drill the reservoirs ahead. In addition to existing developed procedures and practices for ERD wells, subject well was dealing with the challenge of drilling a long 12 ¼" hole with a torque limitation of 30K lbsf.ft on TDS, and 4200 psi on surface equipment, and running the longest casing horizontally at such a shallow TVD, which is being done the first time globally. The success proved that challenging ERD wells can be drilled with optimum investments on rig capabilities.