Evaluation of Robotic Ankle-Foot Orthosis with Different Actuators Using Simscape Multibody for Foot-Drop Patients

Gait cycle plays a major role in human locomotion. Patients with neuromuscular problems are unable to walk normally. Foot drop causes difficulty in lifting the front part of the foot and affects the dorsiflexion (DF) and plantar flexion (PF) motion of the foot. Patient with foot drop must use ankle braces to achieve a normal gait. The existing ankle-foot orthosis (AFO) has its own limitations, as it does not produce adequate PF motion. To overcome this scenario, a study was conducted to analyse the two-degrees-of-freedom (DOF) motion of a robotic ankle foot orthosis (RAFO) with a spring-based series elastic actuator (SEA) and scissor actuator. The objective of this paper is to evaluate the two DOF of RAFO with two different actuators using simscape multibody. The RAFO with actuators were designed using Solidworks, and simulation was carried out using simscape multibody, to analyse the 2-DOF motion. The dynamic motion analysis was carried out using block libraries, bodies, joints, constraints, revolute joints, sensors and a proportional integral (PI) controller. From the simulation results, the total range of motion (ROM) 40° (PF angle of –25° and DF angle of 15°) is achieved by the proposed RAFO with different actuators. Further, based on the results, the input power consumption of spring-based SEA was found to be less than the scissor actuator. Similarly, torque and output power generation of the scissor actuator was found to be greater than spring-based SEA to achieve the normal human ROM. Hence, the designer can choose a hybrid actuator for foot-drop-disorder applications.