Mathematical Models of Additional Measurement Errors of Control Means

Studies have shown that under industrial conditions there is rarely a correction of the current measurement result when the influencing parameter deviates from the normalized value. The existing method of determining the additional measurement error is that in order to obtain the real value of the measurement result, the correction is calculated, which leads to the current value of indexes of control means. The correction value is determined by dividing the degree of the influencing parameter deviation by the normalized value of the additional error. This method of determining the correction is not accurate enough, since it does not take into account the nonlinear dependence of the additional measurement error on the change in the influencing parameter, as well as on the current value of the output signal of control means. To determine the real value of the measured parameter and the additional error, the method of integral-type functional is proposed. The essence of the method is in determining the difference of planes under the nominal and current parts of the static characteristic, limited by the measurement range. It is shown that the planes difference depends on the current and real values of the output signal of control means, as well as on the influencing parameter deviation. The method allows calculating the real values of the measured parameter only by the output signal of control means and the current values of the influencing parameter. The dependencies between the real value of the measured parameter, the current value of the output signal of control means and the influencing parameter deviation are established.