The extrusion of EPDM using an external gear pump: experiments and simulations

Abstract External gear pumps are used in fluid transport systems because of their tight clearances and accurate flow control. These tight clearances are a challenge for numerical studies in terms of spatial discretization. In earlier work, the flow of a viscous fluid in an external gear pump is computed using the finite element method (FEM). An element size based on the respective distance between boundaries is proposed. In this study, results based on the earlier work are compared to extrusion experiments of EPDM. The aim of this study is not only to validate the numerical simulations, but also to determine what material characteristics need to be taken into account for an accurate output prediction of the external gear pump. Especially the introduction of shear-thinning behavior results in an improvement of the amplitude of the pressure difference fluctuation. Taking into account compressibility, alters the torque fluctuation in such a way that it mimics the experiments. Unfortunately, the fluctuation in torque still has a too high amplitude. Eventually, simulations are performed including shear-thinning behavior, a temperature- and pressure-dependent viscosity, and compressibility. The effect of measuring the material behavior using oscillatory or shear experiments is shown. Furthermore, the simulations are applied to a second EPDM. Finally, different processing conditions are tested. For the simulations, only qualitative agreement is found, possibly as a result of the no slip boundary condition.