Progressive collapse behavior of reinforced concrete frame exposed to high temperature

Purpose Technological innovations in the construction field correspond to a wider revolution in metropolitan life and in structural design. With the demand for advanced concrete technology, the introduction of new reinforced materials in concrete, namely, iron, steel and other reinforcing elements. Reinforcement in concrete is developed in the centuries back and several advancements are being stirred to improvise the properties of the concrete through reinforcements. On the basis of this finding from the earlier research studies, a reinforcement methodology is practiced on the current study to investigate the deflection of the M30 mix concrete frame under thermal load conditions. Design/methodology/approach For the examination, corner and the middle frame are considered with the reinforcement provided on four zones with 16-mm diameter for compression and 8-mm diameter is used for the stirrup at 150 mm c/c spacing. The load is applied to the column with live and wall load of 3.5 kN/m and 14.7KN/m. The experimentation is carried out by the finite element analysis strategy in ABAQUS simulation software with five test conditions with the bare frame at single, two and three-bay infill. The model of the frame is developed and meshed with the meshing type of C3D8T under 8-node thermally coupled brick mesh type for the mesh size of 25 mm. Findings From the simulation outcome, the effect of thermal gradient on the reinforced concrete is analyzed and its structural properties are plotted as performance graphs in the result section. Originality/value Under the thermal load condition, the model is simulated for 180 min for five different cases and analyzed the deflection parameters such as deformation, stress and failure rate.