Percutaneous arthrodesis.

It has been generally accepted that residual cartilage and subchondral bone has to be removed in order to get bony fusion in arthrodeses. In 1998 we reported successful fusion of 11 rheumatoid ankles, all treated with percutaneous fixation only. In at least one of these ankle joint there was cartilage left. This was confirmed by arthrotomy in order to remove an osteophyte, which hindered dorsiflexion. More than 25 rheumatoid patients with functional alignment in the ankle joint have subsequently been operated on with the percutaneous technique, and so far we have had only one failure. Patients with rheumatoid arthritis are known to sometimes fuse at least their subtalar joints spontaneously, and the destructive effect of the synovitis on the cartilage could contribute to fusion when using the percutaneous technique. In a rabbit study we therefore tested the hypothesis that even a normal joint can fuse merely by percutaneous fixation. The patella was fixated to the femur with lag screw technique without removal of cartilage, and in 5 of 6 arthrodeses with stable fixation bony fusion followed. Depletion of synovial fluid seemed to be the mechanism behind cartilage disappearance. The stability of the fixation achieved at arthrodesis surgery is an important factor in determining success or failure. Dowel arthrodesis without additional fixation proved to be deleterious. A good fit of the bone surfaces appears necessary. In the ankle joint, it would be technically demanding to retain the arch-shaped geometry of the joint after resection of the cartilage. Normally the joint surfaces are resected to produce flat osteotomy surfaces that are thus easier to fit together, encouraging healing to occur. On the other hand it is considered an advantage to preserve as much subchondral bone as possible, as the strong subchondral bone plate can contribute to the stability of the arthrodesis. Ankle arthrodesis can be successfully performed in patients with rheumatoid arthritis by percutaneous screw fixation without resection of the joint surfaces. This procedure has two advantages: first, it is less surgically traumatic, second, both the arch-shaped geometry and the subchondral bone are preserved, and thus both could contribute to the postoperative stability of the construct. Intuitively, preservation of the arch-shape should increase rotational stability. The results of our experimental sawbone study indicate that the arch shape and the subchondral bone should be preserved when ankle arthrodesis is performed. The importance of this is likely to increase in weak rheumatoid bone. In a finite element study the initial stability provided by two different methods of joint preparation and different screw configurations in ankle arthrodesis, was compared. Better initial stability is predicted for ankle arthrodesis when joint contours are preserved rather than resected. Overall, inserting the two screws at a 30-degree angle with respect to the long axis of the tibia and crossing them above the fusion site improved stability for both joint preparation techniques. The question rose as to whether patients with osteoarthritis could also be operated on solely by percutaneous fixation technique. The first metatarsophalangeal joint in patients with hallux rigidus was chosen as an appropriate joint to test the percutaneous technique. In this small series we have shown that it is possible to achieve bony fusion with a percutaneous technique in an osteoarthrotic joint in humans, but failed to say anything about the fusion rate.