湍流边界层内预混火焰迎面淬火时壁面热流密度和壁面剪应力的分布及其相互关系

IF 2 3区 工程技术 Q3 MECHANICS
Vishnu Mohan, Umair Ahmed, Nilanjan Chakraborty
{"title":"湍流边界层内预混火焰迎面淬火时壁面热流密度和壁面剪应力的分布及其相互关系","authors":"Vishnu Mohan,&nbsp;Umair Ahmed,&nbsp;Nilanjan Chakraborty","doi":"10.1007/s10494-024-00633-4","DOIUrl":null,"url":null,"abstract":"<div><p>The statistical behaviours of wall heat flux and wall shear stress and their interdependence during unsteady head-on quenching of statistically planar turbulent premixed flames within turbulent boundary layers due to heat loss through the cold wall have been analysed using three-dimensional Direct Numerical Simulation data with friction Reynolds numbers of <span>\\(Re_\\tau =110\\)</span> and 180. In both cases, the mean wall shear stress decreases during flame-wall interaction, whereas the mean wall heat flux magnitude increases with time as the flame approaches the wall and eventually assumes a maximum value before decreasing with the progress of flame quenching. The integral length scales of wall heat flux in both streamwise and spanwise directions have been found to grow with time after the maximum mean heat flux magnitude is obtained for the two <span>\\(Re_\\tau\\)</span> cases considered. However, the integral length scale of wall shear stress in the streamwise direction grows but the integral length scale of wall shear stress in the spanwise direction decreases with time after the maximum mean heat flux magnitude is reached. Moreover, the correlation coefficient between the wall heat flux magnitude and wall shear stress becomes increasingly negative while the mean wall heat flux increases with time, but this negative correlation weakens with the progress of flame quenching. The first few (i.e., most energetic) Proper Orthogonal Decomposition (POD) modes of wall shear stress and the wall heat flux magnitude have been found to capture the qualitative nature of the correlation between these quantities and their spatial variations. It is found that tens of most energetic POD modes are needed to capture the mean and variances of wall heat flux and wall shear stress. The number of most energetic modes, which contribute significantly to the statistics of both wall heat flux and wall shear stress, decreases with decreasing <span>\\(Re_\\tau\\)</span> and also with the progress of flame quenching due to the weakening of turbulence effects.</p></div>","PeriodicalId":559,"journal":{"name":"Flow, Turbulence and Combustion","volume":"114 4","pages":"1361 - 1376"},"PeriodicalIF":2.0000,"publicationDate":"2025-01-09","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://link.springer.com/content/pdf/10.1007/s10494-024-00633-4.pdf","citationCount":"0","resultStr":"{\"title\":\"Distributions of Wall Heat Flux and Wall Shear Stress and their Interrelation During Head-on Quenching of Premixed Flames within Turbulent Boundary Layers\",\"authors\":\"Vishnu Mohan,&nbsp;Umair Ahmed,&nbsp;Nilanjan Chakraborty\",\"doi\":\"10.1007/s10494-024-00633-4\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"<div><p>The statistical behaviours of wall heat flux and wall shear stress and their interdependence during unsteady head-on quenching of statistically planar turbulent premixed flames within turbulent boundary layers due to heat loss through the cold wall have been analysed using three-dimensional Direct Numerical Simulation data with friction Reynolds numbers of <span>\\\\(Re_\\\\tau =110\\\\)</span> and 180. In both cases, the mean wall shear stress decreases during flame-wall interaction, whereas the mean wall heat flux magnitude increases with time as the flame approaches the wall and eventually assumes a maximum value before decreasing with the progress of flame quenching. The integral length scales of wall heat flux in both streamwise and spanwise directions have been found to grow with time after the maximum mean heat flux magnitude is obtained for the two <span>\\\\(Re_\\\\tau\\\\)</span> cases considered. However, the integral length scale of wall shear stress in the streamwise direction grows but the integral length scale of wall shear stress in the spanwise direction decreases with time after the maximum mean heat flux magnitude is reached. Moreover, the correlation coefficient between the wall heat flux magnitude and wall shear stress becomes increasingly negative while the mean wall heat flux increases with time, but this negative correlation weakens with the progress of flame quenching. The first few (i.e., most energetic) Proper Orthogonal Decomposition (POD) modes of wall shear stress and the wall heat flux magnitude have been found to capture the qualitative nature of the correlation between these quantities and their spatial variations. It is found that tens of most energetic POD modes are needed to capture the mean and variances of wall heat flux and wall shear stress. The number of most energetic modes, which contribute significantly to the statistics of both wall heat flux and wall shear stress, decreases with decreasing <span>\\\\(Re_\\\\tau\\\\)</span> and also with the progress of flame quenching due to the weakening of turbulence effects.</p></div>\",\"PeriodicalId\":559,\"journal\":{\"name\":\"Flow, Turbulence and Combustion\",\"volume\":\"114 4\",\"pages\":\"1361 - 1376\"},\"PeriodicalIF\":2.0000,\"publicationDate\":\"2025-01-09\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"https://link.springer.com/content/pdf/10.1007/s10494-024-00633-4.pdf\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"Flow, Turbulence and Combustion\",\"FirstCategoryId\":\"5\",\"ListUrlMain\":\"https://link.springer.com/article/10.1007/s10494-024-00633-4\",\"RegionNum\":3,\"RegionCategory\":\"工程技术\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q3\",\"JCRName\":\"MECHANICS\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"Flow, Turbulence and Combustion","FirstCategoryId":"5","ListUrlMain":"https://link.springer.com/article/10.1007/s10494-024-00633-4","RegionNum":3,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q3","JCRName":"MECHANICS","Score":null,"Total":0}
引用次数: 0

摘要

利用摩擦雷诺数分别为\(Re_\tau =110\)和180的三维直接数值模拟数据,分析了统计平面湍流预混火焰在湍流边界层内因冷壁热损失而非定常迎面淬火时壁面热流通量和壁面剪应力的统计行为及其相互关系。两种情况下,在火焰-壁面相互作用过程中,壁面平均剪应力减小,而壁面平均热流量值随着火焰接近壁面而随时间增大,最终达到最大值,然后随着火焰熄灭的进行而减小。在得到两种情况\(Re_\tau\)的最大平均热流量级后,沿流方向和沿展方向的壁面热流的积分长度尺度都随时间增长。在达到最大平均热流强度后,沿流方向的壁面剪应力积分长度尺度增大,沿展向的壁面剪应力积分长度尺度随时间减小。随着时间的推移,壁面热流强度与壁面剪切应力之间的相关系数越来越负,壁面平均热流强度随着时间的增加而增加,但这种负相关随着火焰淬火的进行而减弱。墙体剪切应力和墙体热流强度的前几个(即最具能量的)固有正交分解(POD)模式已被发现捕捉到这些量及其空间变化之间相关性的定性性质。研究发现,要捕捉壁面热流密度和壁面剪应力的均值和方差,需要几十种能量最高的POD模态。对壁面热流密度和壁面剪应力统计都有重要贡献的最高能态的数目随着\(Re_\tau\)的减小以及湍流效应的减弱而随着火焰淬火的进行而减少。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
Distributions of Wall Heat Flux and Wall Shear Stress and their Interrelation During Head-on Quenching of Premixed Flames within Turbulent Boundary Layers

The statistical behaviours of wall heat flux and wall shear stress and their interdependence during unsteady head-on quenching of statistically planar turbulent premixed flames within turbulent boundary layers due to heat loss through the cold wall have been analysed using three-dimensional Direct Numerical Simulation data with friction Reynolds numbers of \(Re_\tau =110\) and 180. In both cases, the mean wall shear stress decreases during flame-wall interaction, whereas the mean wall heat flux magnitude increases with time as the flame approaches the wall and eventually assumes a maximum value before decreasing with the progress of flame quenching. The integral length scales of wall heat flux in both streamwise and spanwise directions have been found to grow with time after the maximum mean heat flux magnitude is obtained for the two \(Re_\tau\) cases considered. However, the integral length scale of wall shear stress in the streamwise direction grows but the integral length scale of wall shear stress in the spanwise direction decreases with time after the maximum mean heat flux magnitude is reached. Moreover, the correlation coefficient between the wall heat flux magnitude and wall shear stress becomes increasingly negative while the mean wall heat flux increases with time, but this negative correlation weakens with the progress of flame quenching. The first few (i.e., most energetic) Proper Orthogonal Decomposition (POD) modes of wall shear stress and the wall heat flux magnitude have been found to capture the qualitative nature of the correlation between these quantities and their spatial variations. It is found that tens of most energetic POD modes are needed to capture the mean and variances of wall heat flux and wall shear stress. The number of most energetic modes, which contribute significantly to the statistics of both wall heat flux and wall shear stress, decreases with decreasing \(Re_\tau\) and also with the progress of flame quenching due to the weakening of turbulence effects.

求助全文
通过发布文献求助,成功后即可免费获取论文全文。 去求助
来源期刊
Flow, Turbulence and Combustion
Flow, Turbulence and Combustion 工程技术-力学
CiteScore
5.70
自引率
8.30%
发文量
72
审稿时长
2 months
期刊介绍: Flow, Turbulence and Combustion provides a global forum for the publication of original and innovative research results that contribute to the solution of fundamental and applied problems encountered in single-phase, multi-phase and reacting flows, in both idealized and real systems. The scope of coverage encompasses topics in fluid dynamics, scalar transport, multi-physics interactions and flow control. From time to time the journal publishes Special or Theme Issues featuring invited articles. Contributions may report research that falls within the broad spectrum of analytical, computational and experimental methods. This includes research conducted in academia, industry and a variety of environmental and geophysical sectors. Turbulence, transition and associated phenomena are expected to play a significant role in the majority of studies reported, although non-turbulent flows, typical of those in micro-devices, would be regarded as falling within the scope covered. The emphasis is on originality, timeliness, quality and thematic fit, as exemplified by the title of the journal and the qualifications described above. Relevance to real-world problems and industrial applications are regarded as strengths.
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术官方微信