无剪切作用下长链支化对宽温度范围聚丙烯成核结晶的影响

IF 5.2 1区 化学 Q1 POLYMER SCIENCE
Xinyan Chen, Ricardo Arpad Pérez-Camargo, Pan Ma, Yilong Liao, Ying Zhao*, Jin-Yong Dong, Xia Dong, Alejandro J. Müller* and Dujin Wang*, 
{"title":"无剪切作用下长链支化对宽温度范围聚丙烯成核结晶的影响","authors":"Xinyan Chen,&nbsp;Ricardo Arpad Pérez-Camargo,&nbsp;Pan Ma,&nbsp;Yilong Liao,&nbsp;Ying Zhao*,&nbsp;Jin-Yong Dong,&nbsp;Xia Dong,&nbsp;Alejandro J. Müller* and Dujin Wang*,&nbsp;","doi":"10.1021/acs.macromol.4c0225610.1021/acs.macromol.4c02256","DOIUrl":null,"url":null,"abstract":"<p >Even though the crystallization of long-chain branched polypropylene (LCB-PP) has been widely studied, the role of long-chain branches within isotactic polypropylene (<i>i</i>PP) under shear-free conditions and a comprehensive understanding of its isothermal crystallization kinetics over a wide crystallization temperature (<i>T</i><sub>c</sub>) range are still lacking. The samples in this work were prepared by solution casting to eliminate any possible shear effects. Then, the impact of LCB on the crystallization behavior of <i>i</i>PP with varying content of long-chain branches (LCB) was investigated in the entire crystallization window range. Polarized light optical microscopy (PLOM) and scanning electron microscopy (SEM) revealed that the <i>i</i>PP nucleation density increased with branching content. Standard differential scanning calorimetry (DSC) and ultrafast scanning chip calorimetry (or FSC, fast scanning calorimetry) showed that the overall crystallization rates had different dependence on the branching content across a wide temperature range (5–136 °C). Above 95 °C, only the α-phase of <i>i</i>PP formed, with an increasing crystallization rate with branching content. In addition to the typical heterogeneous nucleation, the LCBs provoke a significant increase in the nucleation density through a homogeneous nucleation process triggered by the topological constraints of the segments linked to the branch point. These constraints stabilize the PP chain’s helical structure and facilitate the self-assembly of these neighboring chains into primary nuclei. Between 45 and 95 °C, the crystallization rates with varying branching content did not show a specific trend, as there was a competition between primary nucleation and diffusion. Below 45 °C, where supercooling was high and homogeneous nucleation became dominant, the crystallization rates were similar for LCB-PP and neat linear <i>i</i>PP. This work deepens the understanding of the role of LCB in <i>i</i>PP crystallization, providing critical insights into both the nucleation mechanisms and crystallization kinetics of polymers over a broader <i>T</i><sub>c</sub> range.</p>","PeriodicalId":51,"journal":{"name":"Macromolecules","volume":"57 24","pages":"11599–11613 11599–11613"},"PeriodicalIF":5.2000,"publicationDate":"2024-12-09","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":"{\"title\":\"Impact of Long-Chain Branching on Polypropylene Nucleation and Crystallization over a Wide Temperature Range without the Influence of Shear\",\"authors\":\"Xinyan Chen,&nbsp;Ricardo Arpad Pérez-Camargo,&nbsp;Pan Ma,&nbsp;Yilong Liao,&nbsp;Ying Zhao*,&nbsp;Jin-Yong Dong,&nbsp;Xia Dong,&nbsp;Alejandro J. Müller* and Dujin Wang*,&nbsp;\",\"doi\":\"10.1021/acs.macromol.4c0225610.1021/acs.macromol.4c02256\",\"DOIUrl\":null,\"url\":null,\"abstract\":\"<p >Even though the crystallization of long-chain branched polypropylene (LCB-PP) has been widely studied, the role of long-chain branches within isotactic polypropylene (<i>i</i>PP) under shear-free conditions and a comprehensive understanding of its isothermal crystallization kinetics over a wide crystallization temperature (<i>T</i><sub>c</sub>) range are still lacking. The samples in this work were prepared by solution casting to eliminate any possible shear effects. Then, the impact of LCB on the crystallization behavior of <i>i</i>PP with varying content of long-chain branches (LCB) was investigated in the entire crystallization window range. Polarized light optical microscopy (PLOM) and scanning electron microscopy (SEM) revealed that the <i>i</i>PP nucleation density increased with branching content. Standard differential scanning calorimetry (DSC) and ultrafast scanning chip calorimetry (or FSC, fast scanning calorimetry) showed that the overall crystallization rates had different dependence on the branching content across a wide temperature range (5–136 °C). Above 95 °C, only the α-phase of <i>i</i>PP formed, with an increasing crystallization rate with branching content. In addition to the typical heterogeneous nucleation, the LCBs provoke a significant increase in the nucleation density through a homogeneous nucleation process triggered by the topological constraints of the segments linked to the branch point. These constraints stabilize the PP chain’s helical structure and facilitate the self-assembly of these neighboring chains into primary nuclei. Between 45 and 95 °C, the crystallization rates with varying branching content did not show a specific trend, as there was a competition between primary nucleation and diffusion. Below 45 °C, where supercooling was high and homogeneous nucleation became dominant, the crystallization rates were similar for LCB-PP and neat linear <i>i</i>PP. This work deepens the understanding of the role of LCB in <i>i</i>PP crystallization, providing critical insights into both the nucleation mechanisms and crystallization kinetics of polymers over a broader <i>T</i><sub>c</sub> range.</p>\",\"PeriodicalId\":51,\"journal\":{\"name\":\"Macromolecules\",\"volume\":\"57 24\",\"pages\":\"11599–11613 11599–11613\"},\"PeriodicalIF\":5.2000,\"publicationDate\":\"2024-12-09\",\"publicationTypes\":\"Journal Article\",\"fieldsOfStudy\":null,\"isOpenAccess\":false,\"openAccessPdf\":\"\",\"citationCount\":\"0\",\"resultStr\":null,\"platform\":\"Semanticscholar\",\"paperid\":null,\"PeriodicalName\":\"Macromolecules\",\"FirstCategoryId\":\"92\",\"ListUrlMain\":\"https://pubs.acs.org/doi/10.1021/acs.macromol.4c02256\",\"RegionNum\":1,\"RegionCategory\":\"化学\",\"ArticlePicture\":[],\"TitleCN\":null,\"AbstractTextCN\":null,\"PMCID\":null,\"EPubDate\":\"\",\"PubModel\":\"\",\"JCR\":\"Q1\",\"JCRName\":\"POLYMER SCIENCE\",\"Score\":null,\"Total\":0}","platform":"Semanticscholar","paperid":null,"PeriodicalName":"Macromolecules","FirstCategoryId":"92","ListUrlMain":"https://pubs.acs.org/doi/10.1021/acs.macromol.4c02256","RegionNum":1,"RegionCategory":"化学","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q1","JCRName":"POLYMER SCIENCE","Score":null,"Total":0}
引用次数: 0

摘要

尽管长链支化聚丙烯(LCB-PP)的结晶已经得到了广泛的研究,但在无剪切条件下,长链支在等规聚丙烯(iPP)中的作用以及在宽结晶温度(Tc)范围内对其等温结晶动力学的全面了解仍然缺乏。为了消除任何可能的剪切影响,本工作中的样品是通过溶液铸造制备的。然后,在整个结晶窗口范围内研究了LCB对不同长链支含量的iPP结晶行为的影响。偏光光学显微镜(PLOM)和扫描电镜(SEM)显示,iPP成核密度随支链含量的增加而增加。标准差示扫描量热法(DSC)和超快扫描芯片量热法(或FSC,快速扫描量热法)表明,在较宽的温度范围内(5-136℃),总体结晶速率对支链含量有不同的依赖。在95℃以上,iPP只形成α-相,且随着支链含量的增加,结晶速率增加。除了典型的非均相成核外,lcb还通过与分支点相连的片段的拓扑约束触发的均匀成核过程,引起成核密度的显著增加。这些约束稳定了PP链的螺旋结构,促进了这些相邻链自组装成初生核。在45 ~ 95℃之间,不同分支含量的结晶速率没有表现出特定的趋势,这是由于初生成核和扩散之间存在竞争。当温度低于45℃时,LCB-PP的结晶速率与纯线性iPP的结晶速率相似。这项工作加深了对LCB在iPP结晶中的作用的理解,在更宽的Tc范围内为聚合物的成核机制和结晶动力学提供了关键的见解。
本文章由计算机程序翻译,如有差异,请以英文原文为准。

Impact of Long-Chain Branching on Polypropylene Nucleation and Crystallization over a Wide Temperature Range without the Influence of Shear

Impact of Long-Chain Branching on Polypropylene Nucleation and Crystallization over a Wide Temperature Range without the Influence of Shear

Even though the crystallization of long-chain branched polypropylene (LCB-PP) has been widely studied, the role of long-chain branches within isotactic polypropylene (iPP) under shear-free conditions and a comprehensive understanding of its isothermal crystallization kinetics over a wide crystallization temperature (Tc) range are still lacking. The samples in this work were prepared by solution casting to eliminate any possible shear effects. Then, the impact of LCB on the crystallization behavior of iPP with varying content of long-chain branches (LCB) was investigated in the entire crystallization window range. Polarized light optical microscopy (PLOM) and scanning electron microscopy (SEM) revealed that the iPP nucleation density increased with branching content. Standard differential scanning calorimetry (DSC) and ultrafast scanning chip calorimetry (or FSC, fast scanning calorimetry) showed that the overall crystallization rates had different dependence on the branching content across a wide temperature range (5–136 °C). Above 95 °C, only the α-phase of iPP formed, with an increasing crystallization rate with branching content. In addition to the typical heterogeneous nucleation, the LCBs provoke a significant increase in the nucleation density through a homogeneous nucleation process triggered by the topological constraints of the segments linked to the branch point. These constraints stabilize the PP chain’s helical structure and facilitate the self-assembly of these neighboring chains into primary nuclei. Between 45 and 95 °C, the crystallization rates with varying branching content did not show a specific trend, as there was a competition between primary nucleation and diffusion. Below 45 °C, where supercooling was high and homogeneous nucleation became dominant, the crystallization rates were similar for LCB-PP and neat linear iPP. This work deepens the understanding of the role of LCB in iPP crystallization, providing critical insights into both the nucleation mechanisms and crystallization kinetics of polymers over a broader Tc range.

求助全文
通过发布文献求助,成功后即可免费获取论文全文。 去求助
来源期刊
Macromolecules
Macromolecules 工程技术-高分子科学
CiteScore
9.30
自引率
16.40%
发文量
942
审稿时长
2 months
期刊介绍: Macromolecules publishes original, fundamental, and impactful research on all aspects of polymer science. Topics of interest include synthesis (e.g., controlled polymerizations, polymerization catalysis, post polymerization modification, new monomer structures and polymer architectures, and polymerization mechanisms/kinetics analysis); phase behavior, thermodynamics, dynamic, and ordering/disordering phenomena (e.g., self-assembly, gelation, crystallization, solution/melt/solid-state characteristics); structure and properties (e.g., mechanical and rheological properties, surface/interfacial characteristics, electronic and transport properties); new state of the art characterization (e.g., spectroscopy, scattering, microscopy, rheology), simulation (e.g., Monte Carlo, molecular dynamics, multi-scale/coarse-grained modeling), and theoretical methods. Renewable/sustainable polymers, polymer networks, responsive polymers, electro-, magneto- and opto-active macromolecules, inorganic polymers, charge-transporting polymers (ion-containing, semiconducting, and conducting), nanostructured polymers, and polymer composites are also of interest. Typical papers published in Macromolecules showcase important and innovative concepts, experimental methods/observations, and theoretical/computational approaches that demonstrate a fundamental advance in the understanding of polymers.
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
确定
请完成安全验证×
copy
已复制链接
快去分享给好友吧!
我知道了
右上角分享
点击右上角分享
0
联系我们:info@booksci.cn Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。 Copyright © 2023 布克学术 All rights reserved.
京ICP备2023020795号-1
ghs 京公网安备 11010802042870号
Book学术文献互助
Book学术文献互助群
群 号:604180095
Book学术官方微信