Production time and practicability of 3D-Printed wrist orthoses versus low temperature thermoplastic wrist orthoses.

Introduction: In recent years, three-dimensional (3D) printing has emerged as a new manufacturing technique for orthoses, showing comparable stability and wearing comfort to traditional orthoses. However, the lengthy designing and printing process is assumed to take more time than the common practice of manufacturing low-temperature thermoplastic orthoses (LTTOs). The aim of this prospective cross-sectional study was to compare the production time of 3D-printed orthoses (3DPO) to LTTOs.

Methods: The active and passive time needed to manufacture the orthoses was measured in a clinical setting. 17 orthoses (8 3DPOs and 9 LTTOs) were included in the data analysis.

Results: The mean total production time of a 3DPO (12:14:50h total time; 0:44:35h active production time) was significantly longer than in LTTOs (0:14:14h; p < 0.001).

Discussion: The longer production time might be a hurdle regarding the implementation of 3DPOs in hand therapy. Although 3D-printing might become more cost- and time-efficient due to future developments in technology and growing experience, some practical advantages of LTTOs prevail, such as the fast and efficient provision of orthoses and the adaptability of the material if subsequent changes are needed. A combination of both manufacturing techniques may be a feasible solution to provide patient-centred orthosis provision in future hand therapy practice.